|
|
引用第8楼bob_dai于2010-12-16 00:05发表的 :! J6 ^4 a9 r- E. W# F
the softening temperature of the material is determined on a separate specimen, under the conditions a" ^2 m {3 o# Z$ B5 T
specified in ISO 306 with a heating rate of 50 °C/h and modified as follows:
6 V8 H+ f5 M9 O% D# p# j4 C; \. {1 H– the depth of penetration is 0,1 mm;
% L, P) u% l$ v1 }– the total thrust of 10 N is applied before the dial gauge is set to zero or its initial reading noted.
7 D9 j+ H5 [$ f; f* n8 u
0 t; R( ^9 @0 K( D' v.......
2 \4 L$ r/ i; i9 l1 G- [1 d4 T补充八楼的说法,测试设备最好是可以实现自动控制功能的设备,例如在设定限值为0.1mm时,只要变形深度超过0.1mm,那么测试设备会自动停止加热,马上记录软化温度并显示出来。 |
|