|
|

楼主 |
发表于 2011-6-9 16:05
|
显示全部楼层
仔细看Annex C 中的C.1 overload test,
2 a* g" j% y$ a! uC.1 Overload test5 O% p7 l4 B$ a, k* V0 K" ^
If the tests in this clause are conducted under simulated conditions on the bench, these( c" A' T. m: r G5 v
conditions shall include any protection device that would protect the transformer in the
3 ]# e- Q6 S/ L: o; Z1 ^5 a0 Wcomplete equipment.& \' c1 B$ }7 l" R' h
Transformers for switch mode power supply units are tested in the complete power supply unit- U5 Q. \9 t F; a( c
or in the complete equipment. Test loads are applied to the output of the power supply unit.
# b- |/ ~: t) E3 R, p5 j9 P: KA linear transformer or a ferro-resonant transformer has each secondary winding loaded in
& U3 E! n, I7 P' B: f8 e9 M+ xturn, with any other secondaries loaded between zero and their specified maxima to result in
" i* B# M2 t' G; `: g* r0 u9 d1 g* ?) tthe maximum heating effect.2 _& w9 f+ A2 @ j* _- A
The output of a switch mode power supply unit is loaded to result in the maximum heating
$ Z% L& [& ?" \effect in the transformer.
9 q% M% k$ M9 [2 g# Q* qNOTE For examples of loading to give the maximum heating effect, see Annex X.
( d7 K5 N% o$ i x1 }" k5 ]Where an overload cannot occur or is unlikely to create a hazard, the above tests are not4 p! R k0 r# c# B1 n9 u6 Q
made.3 b" u d3 P& ^1 v; [
最后这句话:Where an overload cannot occur or is unlikely to create a hazard, the above tests are not made.# L7 w1 G. ?# }* r* X
我觉得可以作为不用做过载的依据。 |
|