|
|

楼主 |
发表于 2011-4-13 15:29
|
显示全部楼层
yuqijun 兄弟,首先放电管肯定是满足不了基本绝缘的,就算是MOV挂接在PE上,也是有要求的,不是所有的设备都可以的。见标准如下:: k7 y: S) ^5 e7 k
Equipment with such a VDR bridging BASIC INSULATION shall be one of the following:
9 m/ b7 m) f7 Y5 e8 d+ w. P− PLUGGABLE EQUIPMENT TYPE B; or$ E: |- ]7 E+ L! k8 T
− PERMANENTLY CONNECTED EQUIPMENT; or+ L) \+ g, H4 X6 ]. G" A' a
− equipment that has provision for a permanently connected PROTECTIVE EARTHING: H3 ]3 H$ W& \4 H/ J
CONDUCTOR and is provided with instructions for the installation of that conductor. W0 d: p( h" n$ s
NOTE In Finland, Norway and Sweden, the third dashed item is applicable only to equipment as defined in the9 o1 q1 R) g. B, k+ [7 i
Note to 6.1.2.2.; M9 r( G; M/ H% i) y5 p! {: E
Compliance is checked by inspection.
. A! X" T4 Z; u/ n, o0 _也就是说你的产品要是那三个类型的其中之一,才可以用MOV接在PE上,否则是不行的,标准里面有明文规定。但目前机构内部自己做了一个协议,如果产品不是那三种类型的,可以用MOV和放电管串联,当然还有热保险,这样可以接到PE. |
|