|
|
关于ETL logo的大小问题, 我发邮件问了ITS那边,他们给我回复了, 我摘抄了其中的一段话出来:) q3 W. Y& ?: |/ r
• You may enlarge or reduce the Mark proportionally,3 Q& i, @7 c& O0 A' M$ S
but it cannot be changed in any other way. Care
/ i2 n; o* o4 h$ w6 v* A1 fshould be taken when printing a Mark on a
+ ~7 Z* B! c4 z: f! F3 Qproduct, this should be as large as the space will
1 S' _0 m+ R/ ^allow, typically above 13mm wide (0.5”). Printing8 F6 j6 N. I# U- E* r* q( P
of smaller sized marks is allowed, but all parts of
5 y+ N2 I4 q0 h& }6 P# }the mark must be clearly legible when viewed
( t/ i5 i5 n( q6 |7 Q/ Fon the product. The registration symbol, ®, or8 m# Q4 [8 n3 j+ e1 y$ V+ [
CM (where applicable) must be visible. In special
( {( D5 j! b3 Q& \circumstances where the physical size of the/ n, O7 c& b- j; g0 e! E
product means that this is not possible then you
' B! O, p h" h, I8 O! ?7 ~0 umay apply for authorisation to use an alternative
( y0 G8 P. m: p1 |# ~“small variant” of the Mark, obtainable from your, l5 b7 b% g. L1 n7 b
local certification office. On literature, the minimum+ f; j# x& p4 d
size of reproduction should be 25mm (1”) wide. |
|