|
|
关于ETL logo的大小问题, 我发邮件问了ITS那边,他们给我回复了, 我摘抄了其中的一段话出来:
+ \& A' B: @, z% r) M) ^• You may enlarge or reduce the Mark proportionally,
- @ T$ j; n) O8 Mbut it cannot be changed in any other way. Care
% @# r U8 q% H- a+ Sshould be taken when printing a Mark on a" w R! W# T4 K, P: s7 M
product, this should be as large as the space will
9 d. k# H( ^3 A3 u; B3 @allow, typically above 13mm wide (0.5”). Printing) k: ~, T# D' W( U6 c
of smaller sized marks is allowed, but all parts of% E8 Z; a6 ^4 F5 V$ ~) J
the mark must be clearly legible when viewed
]/ a) Y9 V# R: m6 k* D* T6 S6 {on the product. The registration symbol, ®, or" S9 C3 q6 N( V+ Y
CM (where applicable) must be visible. In special# n% N+ S# K. W2 m3 b7 x
circumstances where the physical size of the1 v5 s8 `) A, m1 G4 h0 v
product means that this is not possible then you
+ y7 A/ U/ d. L. Wmay apply for authorisation to use an alternative% I- p5 L& r. @% i; B" o
“small variant” of the Mark, obtainable from your) A o) I+ c4 e0 C
local certification office. On literature, the minimum3 V1 M% V' B* r0 d
size of reproduction should be 25mm (1”) wide. |
|
/1 
|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网
( 粤ICP13023453-10 )
窥视卡
雷达卡
发表于 2010-9-17 15:12
显身卡