|
|
引用第2楼demon_life于2007-10-10 10:28发表的 :8 _( K5 C. O1 ~9 v R: a! S$ S
哦,谢谢~,
0 x. J. u. n/ v- }那可否具体点说CE,和FCC的呢,我现在需要着两家的相关要求,可否告知?9 o3 T- G' l, `5 m2 c6 U
1. 铭牌上的要求2 d( B) ^$ w4 s; L5 s" N9 g! q/ U
2. 纸箱上的要求
7 r& c5 k1 G" | e) p谢谢~
) S) g* C4 x( L; z+ s& c外箱一般有ce即可, 尺寸參照lvd/emc/md等指令上都有ce標誌的要求的.
/ r! ~& b+ p, G* h( }7 z ~fcc, 沒有仔細研究, 你可以參考一下cfr47的要求, 比如part15就有如下要求:
8 m) u: \/ R& O$ k, [& a1 c8 L% H# M3 q# y' u
§ 15.19 Labelling requirements.
3 d8 Q* b) o7 E, D( R(a) In addition to the requirements in
: x( B m# h; H, ^part 2 of this chapter, a device subject0 ~; g$ G) K* m- I
to certification, or verification shall be( S% s" ?# l6 K& ^
labelled as follows:- S) R1 u" g$ K) P, _7 l
(1) Receivers associated with the operation
. A3 |; T4 L+ e' C. l$ \of a licensed radio service, e.g.,' q6 n% Y/ }$ f* R" v
FM broadcast under part 73 of this3 D/ m" o7 Y) T: a* ^* A
chapter, land mobile operation under( _2 a6 r( o8 e: A) T4 H6 u% A
part 90, etc., shall bear the following
; d) [' U% N. C) qstatement in a conspicuous location on- \$ W1 B. q5 ^! _/ @: X
the device:' l* l' ?; M, S% S5 b
This device complies with part 15 of the
$ Q2 F8 |* [$ t; qFCC Rules. Operation is subject to the condition
& Y+ L! N' h6 p! y nthat this device does not cause harmful- M+ K9 C) @$ n8 I; G0 d! i; g
interference.
. d& s2 k) m3 |3 n. v! ]) d' G(2) A stand-alone cable input selector
% a7 q% u& t. ]2 z& O0 Tswitch, shall bear the following statement+ A2 J6 p& }/ v6 I' U# i3 [
in a conspicuous location on the Z$ V4 m- a* }9 G0 A) H" I8 c
device:- B c2 w4 r$ ^/ q8 V8 I
This device is verified to comply with part# h; x0 a4 P+ _/ S
15 of the FCC Rules for use with cable television
# {4 ^% h2 a, ?6 m6 M2 Bservice.
" }+ D" a" x, Z+ ^8 B(3) All other devices shall bear the; Q2 k+ [3 O" r6 \9 `) r N/ p
following statement in a conspicuous& J6 E# A. m+ U8 D. {& q
location on the device:
- S$ C% I6 H5 s. l5 A" Q& [7 C5 VThis device complies with part 15 of the
, O# l2 F: O( y- R9 u5 i! VFCC Rules. Operation is subject to the following1 q& v5 U$ P) ?
two conditions: (1) This device may+ N- \# l4 {$ N* h
not cause harmful interference, and (2) this6 L. F, T& P% k7 r9 _" b# n
device must accept any interference received,7 n3 Q% W ^3 i2 Y+ s
including interference that may
# f# d4 r; n- }( z, l% ocause undesired operation.
- E4 o! Q# C+ S" b+ [+ O(4) Where a device is constructed in
5 @* k+ ~1 o8 T v" Vtwo or more sections connected by% l/ ]+ P. V- k/ z! O# M6 l
wires and marketed together, the% H! a0 j6 V3 h0 |# ^1 {4 a6 D- G
statement specified under paragraph' D. p0 g5 V6 m9 o" N
(a) of this section is required to be affixed( n( \3 O5 E( r" |! Z4 K
only to the main control unit.
& \% e) M ~" ]' V8 d(5) When the device is so small or for
$ L( D# L$ s* I+ tsuch use that it is not practicable to
* O, m% s* g& Q' Z0 P% Xplace the statement specified under
, l! v! e3 b9 e$ T6 R eparagraph (a) of this section on it, the
+ o' K, \" _8 U4 }1 @3 `4 binformation required by this paragraph4 U$ H+ W! x8 e0 X# m C* D) S
shall be placed in a prominent location
0 d( L9 S3 `' C+ L( h5 l# _6 s+ nin the instruction manual or pamphlet
5 w) O0 F% \, `/ A r* asupplied to the user or, alternatively,
* Z) P0 f7 {) L, l7 M+ n. oshall be placed on the container in
( O% i4 t6 ?1 iwhich the device is marketed. However,0 T2 \4 G% ~! a! U, m6 Y5 R5 F
the FCC identifier or the unique identifier,
) v% E. _! U$ r% s T0 Yas appropriate, must be displayed
; M3 M/ \, t- Q! C3 w& xon the device.
, i" `0 R! Q5 ?" J$ z(b) Products subject to authorization
+ X$ i, A# b1 X5 J6 Y3 l/ }/ Lunder a Declaration of Conformity- I8 u1 ^' X) Y
shall be labelled as follows:
% ^; a/ o9 ]4 d6 L(1) The label shall be located in a$ c( V* r# G( T" p( L4 x0 ~
conspicuous location on the device and. u. ~; y& P4 X1 K& r
shall contain the unique identification6 T( j- ?8 r5 `
described in § 2.1074 of this chapter and
$ L, F1 s7 h. i xthe following logo:
9 V5 j# g% r6 X9 v$ T0 s+ ~(i) If the product is authorized based- \3 B# L. _, |& y& i( V
on testing of the product or system; or ~$ v; `8 z- _) Z
(ii) If a personal computer is authorized3 b' Z; H8 f" e" j$ M# b, s
based on assembly using separately( i% K8 g' f5 [- v
authorized components, in accordance
3 W' a! N8 W6 j/ W7 B# Q7 @; N3 lwith § 15.101(c)(2) or (c)(3), and
* j5 G* T+ n1 x/ w- [% L7 Tthe resulting product is not separately
9 @- d6 }& |% ]" T$ ^* t5 Ltested 2) Label text and information should; D: I4 }( X o7 ]
be in a size of type large enough to be. T& G, m4 g% W, Q/ N" a
readily legible, consistent with the dimensions
, ]! c, k, F0 M( ~of the equipment and the
' C1 T+ K' ]! n# elabel. However, the type size for the5 s/ X1 a1 j5 n8 r& x
text is not required to be larger than
/ }; D, U1 U0 a) `eight point.
7 d' V/ i% m2 }/ q4 Y(3) When the device is so small or for( ^4 Z" \9 r% u7 N( R- X" }) [
such use that it is not practicable to
0 V" @4 L* ]6 q& j2 n$ u8 V2 tplace the statement specified under
7 G' @ N: X8 e/ R; `& P+ H! C( |2 y9 M# A* }: P; O5 V
.......................
/ a# m/ E9 h& B4 B) q+ t5 [4 O5 V- W# ~/ j" e* Y6 h
http://a257.g.akamaitech.net/7/2 ... /pdf/47cfr15.19.pdf |
|
/2 
|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网
( 粤ICP13023453-10 ) 
窥视卡
雷达卡
发表于 2007-10-10 10:08
收藏
分享
好帖
鸡蛋
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
发表于 2007-10-10 10:14
楼主
发表于 2007-10-10 10:30
