|
|
引用第2楼demon_life于2007-10-10 10:28发表的 :
, Q; L- ]3 \6 E6 v4 [哦,谢谢~,+ O; Q- P5 W/ a/ W _
那可否具体点说CE,和FCC的呢,我现在需要着两家的相关要求,可否告知?
) Q3 U- M* L& m9 j' g u1. 铭牌上的要求! h2 p) s; r" f7 e( Z
2. 纸箱上的要求0 S. Y- O7 U( l: p+ J" F/ ]
谢谢~
外箱一般有ce即可, 尺寸參照lvd/emc/md等指令上都有ce標誌的要求的.0 O1 R. m* Z6 J3 ?7 ^# E
fcc, 沒有仔細研究, 你可以參考一下cfr47的要求, 比如part15就有如下要求:
, R! U9 @" j1 Z. q& L& w* d
$ q8 s# J$ Q2 Y: ~! [3 u& P8 x4 T§ 15.19 Labelling requirements.
' d3 O+ f) g6 \: h. J$ g! d(a) In addition to the requirements in: i U% [: R9 Y9 y! F! f
part 2 of this chapter, a device subject
2 M- k0 G. a# W, v* I; ~to certification, or verification shall be
9 q; L* e" v; j/ d6 ~ plabelled as follows:0 G( }$ E$ n& W, i$ c
(1) Receivers associated with the operation
) u0 o3 ^9 L9 M8 P. d- Tof a licensed radio service, e.g.,; R# X4 ~7 e, i- l g' Q1 g: k2 u
FM broadcast under part 73 of this
0 k6 g p/ O5 H! Y6 J) Uchapter, land mobile operation under
# K7 G6 u1 |- P2 e7 o+ ?* X) Upart 90, etc., shall bear the following& K) L* d' M9 i3 d2 K7 `
statement in a conspicuous location on2 b" {( V/ q S2 z' L- o
the device:: Q4 ~. n) a- ?9 B0 N5 O7 q- s
This device complies with part 15 of the
# ]3 K9 ~; y W* j2 J! {8 EFCC Rules. Operation is subject to the condition, t- F @% y/ J M- c. ~
that this device does not cause harmful
- G. w8 D1 B$ W- J" t) C2 m" `3 I: iinterference.3 Y3 b1 r! r: [3 Z& Q$ T8 z
(2) A stand-alone cable input selector
$ ^. o8 \9 W8 S9 Gswitch, shall bear the following statement
. i0 z2 G: F( n$ hin a conspicuous location on the, H/ t- q, V; j: C5 Q
device:6 z$ l& X" r) @. g3 A5 Q
This device is verified to comply with part% v, X# C, H/ {& E
15 of the FCC Rules for use with cable television
$ {2 b. P. ^9 X1 X2 U/ u. S/ Uservice.
; Q$ m& a% ]& ?. A! y(3) All other devices shall bear the
6 J1 N- {& S7 L: w& r+ pfollowing statement in a conspicuous
0 X4 y! n/ p8 U* U& Hlocation on the device:4 N5 i$ ~2 R& y, _
This device complies with part 15 of the: I/ \. b3 k, l- k
FCC Rules. Operation is subject to the following. {3 p6 ~8 s, {: p
two conditions: (1) This device may) y$ i. C2 l0 B, A7 f5 v, E" j
not cause harmful interference, and (2) this
* ^( B* \2 C& {device must accept any interference received, X- {5 _( k8 E" R) ~) I
including interference that may
& g% c, r- Q8 bcause undesired operation.
( Q0 E4 P! {4 y- b0 J9 M5 N! p(4) Where a device is constructed in
4 y6 t o" x& F( P& ftwo or more sections connected by
?+ K1 J: u) a& Rwires and marketed together, the! m% ?2 B6 g4 k j5 A, i' _; k
statement specified under paragraph, ^3 a# q( a: ] W
(a) of this section is required to be affixed
+ w$ m0 a2 [9 `( J ]4 U+ Oonly to the main control unit.
- O- M: D& {! |- O6 m4 E(5) When the device is so small or for
6 Z- h1 H5 s& J9 G- _& h* j' Zsuch use that it is not practicable to
s7 ^2 O% l: S! J& bplace the statement specified under
. R/ e. H3 j2 H% F/ h6 K, yparagraph (a) of this section on it, the/ l; N) J; q% ]! x5 W6 n4 X6 O& U* ?
information required by this paragraph
?0 x, g Z4 s D# J- y% k3 \shall be placed in a prominent location q2 g& D" e. i% ], @% G
in the instruction manual or pamphlet
$ {2 P- {, Q, Q% w- X4 Psupplied to the user or, alternatively,
9 t' T5 p% s* ^' p# cshall be placed on the container in
$ n- V5 H, g2 M" `6 mwhich the device is marketed. However,
; z9 m$ s+ k; g( ?; C( cthe FCC identifier or the unique identifier,
! @2 ?7 r3 \- _' Tas appropriate, must be displayed3 C6 g' [. z, J$ P; R
on the device.1 q: Q9 M7 G O/ @. i
(b) Products subject to authorization
* E) \3 D4 J; X7 ~- munder a Declaration of Conformity( }2 r6 h/ p3 X
shall be labelled as follows:
: L: J; A7 w7 z(1) The label shall be located in a7 Y1 t3 S4 m8 ~$ `
conspicuous location on the device and
* {9 j3 w# B! E8 T+ c( P/ ?shall contain the unique identification( v2 m/ [' P) A2 [ y
described in § 2.1074 of this chapter and6 W$ U8 H* f; u
the following logo:! T$ q# v( v& u
(i) If the product is authorized based5 d- `' V- _. v# O, m/ ?
on testing of the product or system; or/ ?; j8 ^" C% O! Y- r/ S3 k
(ii) If a personal computer is authorized: q2 X! K) b1 ^3 x/ [$ J
based on assembly using separately
2 z# ]7 G5 z! L6 i& _authorized components, in accordance% e3 Y" i) F v% R4 \
with § 15.101(c)(2) or (c)(3), and5 L4 P1 z, F& }4 D- a8 c* b, E
the resulting product is not separately
1 M9 e9 L' @: u, vtested 2) Label text and information should
. L/ K* A2 K% t+ I4 R. p! L l5 }be in a size of type large enough to be- l( O% a7 A( c; ^
readily legible, consistent with the dimensions
" O3 V& t' y- l$ g. c6 H( E( Q; fof the equipment and the6 g( r4 z8 d- U$ ~9 ]& |
label. However, the type size for the2 Y. K+ \, R5 j( `. K5 k( I
text is not required to be larger than
% C( k* }0 e. @2 J+ e7 Oeight point.
/ |2 J$ G4 f# p(3) When the device is so small or for' g/ N/ q$ D* }- c
such use that it is not practicable to
! L- U% f% }2 X4 q( y3 `# g/ A, jplace the statement specified under
& H* M/ f5 ?. t, \& a/ @4 T5 u) H2 O: }8 k' I
.......................
+ |! W$ b$ Y3 D9 _) e$ B( I, k5 b E# S, s- D/ j
http://a257.g.akamaitech.net/7/2 ... /pdf/47cfr15.19.pdf |
|
/2 
|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网
( 粤ICP13023453-10 ) 
窥视卡
雷达卡
发表于 2007-10-10 10:08
收藏
分享
好帖
鸡蛋
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
抢沙发
千斤顶
显身卡
楼主
发表于 2007-10-10 10:38
发表于 2007-10-10 10:30
