|
1st (twice) v, u/ P5 X5 x% N* M
Detachable parts are removed.
: A* {( P. i9 \, ]* KThe liquid container of the appliance is completely filled with water containing approximately 1 % NaCl and a further quantity, equal to 15 % of the capacity of the container or 0,25 l, whichever is the greater, is poured in steadily over a period of 1 min.
E V, W) Q1 [& @6 m* e9 j Y3 DIn case of doubt, the spillage test is carried out with the appliance deviating from the normal position of use by an angle not exceeding 5°.$ A; p' e. u/ q
; u" |% J0 W- R1 Z7 {; ~; e' w, F
For cordless kettles, the test with the kettle on the horizontal plane is carried out with the kettle both on and off its stand.
4 W6 k6 F) J* H; p# f' j+ ` o, L- ~, e
6 N! v& L* ? l @8 _
8 p. z0 _2 N9 {! G0 e$ Y2nd -- Kettles that can be filled through the spout
9 P' J, v/ P& b& q8 ^: A! `' D/ [Detachable parts are removed.
6 a1 t) |; V& v# [) |$ Y# HTested on a plane inclined at an angle of 20° to the horizontal, with the spout uppermost.
v& |4 z, { f/ v- Cfilled with water containing approximately 1 % NaCl to the maximum level, if this indication is visible from the filling position, otherwise until water spills from the kettle.
/ |: v8 h/ ]+ y g% Q) ZA further quantity, equal to 15 % of the rated capacity of the kettle, is then added as quickly as possible* |7 T+ N5 c1 D# N, j- Y; |! q/ t7 ?
Only with the cordless kettle off its stand6 f7 e% p, l( G) Y" T2 h" R" \
' k6 p% A+ ~" l+ ~& ~% Q( z1 ]8 x$ L
$ @( j2 t ?: P' r, `4 w/ @3 ^
3rd+ z% Z* J: m! B# u7 o
Kettles are then filled to rated capacity with water.
. R/ f- Q" j* h( N' LThey are placed on a plane inclined at an angle of 20° to the horizontal with their spout facing up the slope of the inclined plane. 2 Z( o0 B/ s! i
Water shall not be discharged from the kettle+ `* w% o% M7 W: y" `
$ t: C8 e0 V) \) x7 q: f! u* w* J8 X4 U* \9 a* `. ]
4 Y$ }) ^. \1 @7 T6 ^4th -- Stands for cordless kettles
( U6 v0 R* @1 {/ K1 v" D) D, `5 RThe stand is placed on a horizontal surface 7 F0 m; ]. c+ u; M) {
30 ml of water containing approximately 1 % NaCl is poured onto the connecting device.
2 S7 l4 Y2 H3 g" W ~The solution is poured steadily through a tube having an inner diameter of 8 mm over a period of 2 s, the lower end of the tube being 200 mm above the connecting device. % Q/ t6 }5 k+ `. {/ C* Z
Judgment:The stand shall then withstand the electric strength test of 16.3, the test voltage for reinforced insulation being 2 500 V. |
|