|
If the following materials and parts are not separated from a PIS according to the4 ]6 N' B% x8 g2 e9 j
requirements of 6.4.7, then the materials and parts shall not ignite during single fault) i+ e; i+ }) u3 m
conditions as specified in 6.4.3.2:
& h! _2 R8 w7 Q2 r5 e& X- ^1 W– supplies, consumable materials, media and recording materials; and; F9 H* H/ `- e7 K
– parts that are required to have particular properties in order to perform intended functions,; T# m' ~2 i& s9 F/ ^: J
such as synthetic rubber rollers, ink tubes and material requiring optical characteristics, {7 f Z+ { s6 b' {( H0 n
PS2中有明确写到补给材料,介质或消耗材料要与PIS进行隔离,要满足5或13的要求,否者用6.4.3.2的单一故障去豁免2 a* g2 o8 { |) I3 [8 E- F$ ~
: V* ~! d' s5 I% s' j/ L
– by providing a fire enclosure as specified in 6.4.8.
: L$ u7 I- @8 \# d$ z( `. uWithin the fire enclosure, combustible materials that do not comply with the flammability
8 u. {$ b- A$ D" W# hrequirements for PS2 or PS3 circuits shall comply with the flammability test of Clause S.1 or( t$ p/ |3 H0 z5 G- b# H9 K
be made of V-2 class material, VTM-2 class material or HF-2 class foamed material.
" E) B* u# j. z6 }These requirements do not apply to:
" r+ Y1 c3 h) N. [) g; R8 ~– parts with a volume of less than 1 750 mm3;
K+ H m2 c5 ^ E, r– parts with a mass of combustible material of less than 4 g;
8 p; d2 F0 J V5 J# @2 A– supplies, consumable materials, media and recording materials;
3 h0 D- }* v6 O– parts that are required to have particular properties in order to perform intended functions,, ^5 v; `- B8 C1 X/ A4 Z
such as synthetic rubber rollers, ink tubes and material requiring optical characteristics;4 q! U" U" F# o3 o- \# a0 g
按6.4.8的规定提供防火防护外壳(V-1),不符合PS2或PS3电路一部分的可燃性材料应符合第S.1章的可燃性试验或应用V-2级材料、VTM-2级材料或HF-2级泡沫材料制成,那么这个时候不考虑PIS的距离的问题,如果材料不符合上述要求,用V-0防火防护外壳或者材料安装在V-1印制板上(考虑PIS距离要求),不知道我的理解是否正确,是因为补给材料,介质或消耗材料无法满足V-2或S.1的要求,所以说不适用吗??那么一个终端产品,定期要更换这些材料,是否像PS2要与PIS进行隔离,个人认为要的。0 t! X; p, T1 y% e+ O, A+ F
, ~) p+ b% I% q" a" Q
1 U5 v- r1 C' d8 f+ u- g |
|