|
Background: OSM 2012 found it useful to have a similar decision for EN 60065 as the decision 01/8 for EN 60950-1. It has lately been questioned by the chairman of IEC TC108/MT1 that the decision 12/2 may amend EN 60065. Thus, we are proposing a revision of 12/2. Ref. OSM/EE – 2007 Item No.7.1 (enclosed):5 p3 ~) X5 f) D6 s% N. z
“OSM decision 01/8 requires markings on the product (e.g. "Use only power supplies listed in the user manual / user instruction." or “For applicable power supplies see user instruction”). Furthermore such sentences shall be in the languages acceptable to the country where the product will be used.
- _8 Y- ~7 K) z$ r# L) hWe cannot assume that all people speak or understand English and therefore it is necessary to put nearly all languages of such relevant safety instructions on the product.1 p* G0 ]" E9 z
That cannot be a solution because many products are too small!”
, U9 O( j: y9 tOSM/EE-2007 agreed to use instead of such instructions (sentences) on the product, international accepted symbols like these both marks (ISO 7000-0434 and ISO 7000-1641):7 t1 W2 m9 Y S4 S4 v# J$ Z
Later it was confirmed by TC108/MT1 that the book only can be used as an alternative. See explanatory notes below. Based on this it is proposed to revise decision 12/2 as amended with red text under the decision below./ @( V2 c( d% g
In case safety of an end apparatus relies upon the power supply for general use (adaptor) to EN 60065 apparatus, the use of the specific adaptor needs to be controlled.
* @( n2 O4 S: C0 ^/ _ l0 nThe safety issues may relate to a reliable insulation, single fault conditions, heating etc.
- D% B! w5 N$ X" J1 B$ jExtract of 5.4 Instructions:
3 m3 s3 Z& P+ h' z2 E, X% yWhen information with regard to safety is required according to this standard, this information
& _6 P+ t b! T/ `$ rshall be given in an instruction for installation or use and supplied with the apparatus. …- l+ i5 y5 m5 e
It would be useful to have a similar Decision for 60065 as the Dec 01/8 to EN 60950-1.4 V! u+ e$ ~4 d) C2 M2 ?* l
Dec 01/8 is enclosed for convenience.
2 [" K0 U. i6 X* K' w% b6 [$ N3 f9 m/ ?$ [! p+ J/ ~
Decision: This decision replaces 12/2 with the amended text in red:5 G$ X/ P0 I9 D
When safety of an apparatus relies upon the power supply (adaptor) using a non-special connector for the a.c./d.c. input, the apparatus must have a marking stating the following: "Use only power supplies listed in the user instructions"
7 ]3 |4 P! Y* A* Ior+ }9 t! f" t8 ]
"For applicable power supplies see user instructions". This statement shall also be in the user-instructions.
, h4 I [3 B0 x$ }4 ~" [7 `! VThe user instructions must then have a listing of manufacturers and models of the relevant power supplies. As an alternative to the text on the product, it is acceptable to use both the symbols ISO 7000-0434 and ISO 7000-1641. The book alone is also sufficient (ISO 7000-1641).
4 K1 F2 C9 S- ~- R& c, _
, Q4 f3 u* e7 t4 p& f9 F |
|