|
关于7.1章:* J% K( P' D) }* `' \! v1 X
7.1 Delete the second and third paragraphs, including the note. i) c) [6 }2 ^' o- b' Z
, Y$ m( F1 v( k2 |4 E& f) T% K请教下到底删除的是哪些信息?是红色部分吗?EN的版本也是一样的吗,谢谢各位了.8 z1 `3 `' s, ]& V ]8 q4 y- u
' t% x' G" r1 | U7.1 Cable reels shall be marked with:
8 P9 E# `( {9 p2 D+ S. b— rated voltage in volts;6 y) I4 w& X- m! W+ M F0 r
— symbol for the nature of supply;
3 d/ l. _' R4 M) [' y— either the name, trade mark or identification mark of the manufacturer or of the vendor responsible;0 q# @) u$ w& u3 n0 i
— type reference, which may be a catalogue number;
4 H( C7 Z. O; ]) _# q) \— symbol for degree of protection against ingress of water if higher than IP20;
4 D5 B0 r% ^8 c) }NOTE The degrees of protection are based on IEC 529.
' J. w6 W( v* s o— maximum load which may be connected to the socket-outlets, to be stated in watts supplemented with & v' K* @/ K* q8 V4 ^+ v: Z/ S
the voltage in volts, for fully-reeled and fully-extended conditions.
+ j: p+ K, k* ], Z/ l6 z4 QEXAMPLE: “1 500 W — 230 V flexible cable fully-reeled,2 V2 K- b9 X' L4 \
3 000 W — 230 V flexible cable fully-extended”." G" V/ j/ p8 V2 q. ~& d4 ?0 L; ^! z
( s, R3 L6 p0 `, ZCable reels not protected against excessive temperature shall, in addition to the marking of the maximum $ G: i* K6 g0 C% w
allowable loads, be marked with:' ~3 D; W W3 m- y# f1 E! h
“WARNING — Do not exceed the maximum allowable load”.
" u5 x+ B& B8 @See Annex ZB for special national conditions and Annex ZC for A-Deviation.
- p" l& z, Y/ TCable reels fitted with a thermal and/or current cut-outs shall be marked with an instruction clearly ! B# A7 ^ ~7 |9 ^. X; Z
stating how to reset the device.0 c: }' S5 J) C" D" g% [% B
NOTE Cable reels may additionally be marked with rated current in amperes
, H0 V* M9 ?1 n. w/ X1 t/ \
* |$ h4 `7 R, D0 ^7 D2 m6 F! [
" e' M- B; J9 t0 ^- x |
|