本帖最后由 H-RH 于 2013-6-30 01:28 编辑
& Y, @* ]: @( [, n' w& q! c5 E* V
你说的应该属于 UL 982 Section 22.4 及 66.25.1 "with a stop position while energized"
# c1 n3 c) G8 h: J+ \& q5 z+ E7 E+ @$ P) O+ C5 Z2 @
) h% X! W5 P1 K$ P3 ] B5 p: {22.4 If a malfunction or breakdown of an electronic component, located in any circuit of the product, results in increased risk of injury to persons, such as a loss of OFF control or unexpected operation, that circuitry shall comply with the requirements in the Standard for Tests for Safety-Related Controls Employing Solid-State Devices, UL 991. A single malfunction is to be considered at a time.
4 G5 H) L6 b' X0 e' U% S7 ?2 bException: An appliance employing exposed moving parts and electronic controls with a "STOP" position, where a single malfunction of a component can cause unexpected operation, shall be provided with a motor control OFF switch in accordance with 17.4 and be constructed with a red light which flashes only when the appliance is energized and when the motor is in a stop condition but not OFF. See also 66.25 and 70.32.
* q: B8 Z8 n. `66.25.1 Products employing exposed moving parts and electronic controls with a stop position while energized, and required to be provided with a flashing light in accordance with the Exception to 22.4: ....
* Z+ U/ G9 c5 b7 S7 [) B1 K* z R7 Q- H
4 U* h3 m' y( ^8 J4 w即电源已经启动(energized), 但操作在 stop position, 要求闪烁之红灯(red flashing light)!
7 `( d0 F0 o. k# f* K在 Certification Requirement Decision (2012-01-13) 又作了少许更改, 不一定要 red light:
0 O% r" s7 r! n& [. |7 e% g1 T: O' a, ^1 ~% ^
0 ~1 f5 i% M( @% L0 m.... shall be provided with a motor control OFF switch in accordance with 17.4 and be constructed with a light which flashes only when the appliance is energized and when the motor is in a stop condition but not OFF. . w, `% A0 |2 W9 Y2 W0 j
/ [& k- W$ ]0 I, T |