安规网

用户名  找回密码
 注册安规
安规论坛 | 仪器设备 | 求职招聘 | 国家标准 公告 | 教程 | 家电 | 灯具 | 环保 | ITAV 签到 充值 在线 打卡 设备 好友| 帖子| 空间| 日志| 相册
IP淋雨机 | 证书查询 | 规范下载 | 资质查询 招聘 | 考试 | 线缆 | 玩具 | 标准 | 综 合 红包 邮箱 打卡 工资 禁言 分享| 记录| 道具| 勋章| 任务
水平垂直燃烧机 | 针焰 | 灼热丝 | 漏电起痕
IP防水防尘设备|拉力机|恒温恒湿|标准试验指
灯头量规|插头量规|静风烤箱|电池设备|球压
万年历 | 距劳动节还有21天14小时39分21秒
自2007年5月10日,安规网已运行 6544天
2025年4月9日 星期三 上午 9 点 20 分 38 秒
IP淋雨设备| 恒温恒湿箱| 拉力机| 医疗检测设备ASTC+那尔|沙特SASO Saber GCC 埃及COC水平垂直燃烧机|灼热丝|针焰试验机|漏电起痕试验机
灯头量规|试验指|插头插座量规|灯具检测设备耐划痕试验机|可程式恒温恒湿试验箱 | 耦合器设备广东安规-原厂生产-满足标准-审核无忧
查看: 1092|回复: 6

[综合话题] 如图 倾斜测试需要将玻璃缸拿出来吗?

[复制链接]
发表于 2012-8-14 20:21 | 显示全部楼层 |阅读模式
广东安规检测
有限公司提供:
如图15°倾斜测试需要将玻璃缸拿出来,盖子打开吗?
+ B7 E) ]% \/ s; y5 k) a% Z1 ^: k% ?8 X
- I& R3 R1 V& Q! X. |' L5 T
 楼主| 发表于 2012-8-15 19:15 | 显示全部楼层
本帖最后由 329485466 于 2012-8-15 19:21 编辑
4 f4 i  O/ S9 L, D
520168 发表于 2012-8-15 08:52 ' f% p& y6 R  e3 K; B
15°倾斜测试不需要将玻璃缸拿出来,盖子打开测试一次,盖子关闭测试一次.. k4 b& N% a' z/ h  O9 K, ~
倾斜测试应该是测正常使用时最不 ...

/ @- t* B+ o5 i! S) G
0 z. F/ _' s; m# r8 }+ ?10°倾斜测试是不是也不用把玻璃缸拿出来,
7 F4 s1 S4 }3 Y3 x现做3C,测试机构要求把玻璃缸拿出来,锅盖打开。6 g7 j; g. I# p
锅盖打开可以理解,
2 [& u. q4 z& t' i! n玻璃缸拿出来就有点不能理解了。6 C) @! R/ r4 D9 B3 W/ `; \& @
玻璃缸只有在清洗时才拿出来,不知这算正常使用不?5 q  c- o) V3 z/ p

( R) i! O2 g' L6 |% P% j不知是否可通过说明书来避免拿出玻璃缸来做10°倾斜的测试?* Y2 c4 K1 I. D  O
玻璃缸不拿出来,10°和15°都能过。
回复 支持 0 反对 1

使用道具 举报

发表于 2012-8-14 22:28 | 显示全部楼层
建议楼主仔细看下标准第20章,说的很清楚:
& k! a# o  s" }- {20 Stability and mechanical hazards) B3 O0 r) z7 j" m
20.1 Appliances, other than fixed appliances and hand-held appliances, intended to be) n. }' k# Q( `7 _7 Y
used on a surface such as the floor or a table shall have adequate stability.0 V+ [* R3 f0 b, Z1 c- E( Y
Compliance is checked by the following test, appliances incorporating an appliance inlet being# _4 r6 ?$ J+ W- h5 Y# ^9 r
fitted with an appropriate connector and flexible cord.& W2 G* k9 X; t" ?8 f& ]" t7 C
The appliance is placed in any normal position of use on a plane inclined at an angle of 10° to
- J# K, C* e. V' W/ d& U* ]the horizontal, the supply cord resting on the inclined plane in the most unfavourable
( V. D! u! v: _! o9 u& B( b; @9 e( iposition. However, if part of an appliance comes into contact with the horizontal supporting/ S0 S, D7 i1 L* g$ r2 h
surface when the appliance is tilted through an angle of 10°, the appliance is placed on a
# K# v4 b& ^& @) N  C4 T7 A0 |( mhorizontal support and tilted in the most unfavourable direction through an angle of 10°.2 x! @, a' e! ~* P3 M
NOTE 1 The appliance is not connected to the supply mains.+ [' k! f" O7 G
NOTE 2 The test on the horizontal support may be necessary for appliances provided with rollers, castors or feet.$ S" @+ }/ u2 N) ^! V* @" r
NOTE 3 Castors or wheels are blocked to prevent the appliance from rolling.0 {( W! m# ]6 x
Appliances provided with doors are tested with the doors open or closed, whichever is the
; R+ d0 `( }) m0 _/ M! o2 }more unfavourable.
% @. p- K% o# b' U, V. [( p' m' S! WAppliances intended to be filled with liquid by the user in normal use are tested empty or filled
! {+ ^, ^0 F3 {- U. p) Dwith the most unfavourable quantity of water up to the capacity indicated in the instructions.
' Z+ f- c) v' o& i2 H8 YThe appliance shall not overturn.2 [, Z$ M$ I& l% D/ y# U0 T
The test is repeated on appliances with heating elements with the angle of inclination1 c; R* Y' `# {' `6 H
increased to 15°. If the appliance overturns in one or more positions, it is subjected to the' M( l0 L% o: f
tests of clause 11 in each of these overturned positions.
6 e$ D( s: N8 U) }& WDuring this test, temperature rises shall not exceed the values shown in table 9.

点评

谢谢! 之前看过几遍,现在又看了下,就不知道玻璃缸,该不该拿出来。 如果玻璃缸拿出清洗不算正常工作,我认为测试可以不用拿出玻璃缸。  发表于 2012-8-15 19:27
发表于 2012-8-15 08:45 | 显示全部楼层
The test is repeated on appliances with heating elements with the angle of inclination
: E% O; \" ]" l: u/ w* l" U4 m" B; s+ @# Eincreased to 15°.
发表于 2012-8-15 08:52 | 显示全部楼层
15°倾斜测试不需要将玻璃缸拿出来,盖子打开测试一次,盖子关闭测试一次.
9 T4 v' d, \* f倾斜测试应该是测正常使用时最不利的位置

点评

关键是玻璃缸被拿出来,10°都过不了, 15°测试过不了,大不了做温升测试,呵呵。  发表于 2012-8-15 19:30
发表于 2012-8-15 09:56 | 显示全部楼层
同意楼上的观点
发表于 2012-8-16 08:41 | 显示全部楼层
我也觉得玻璃缸拿出来不合理,LZ有没有问3C机构为什么要拿出来?
& g4 a5 s1 |' I  `/ s. X  u' I. U1 ~' J, Z  r, `' m7 [8 c2 Y5 f. Y
LZ有没有试过拿出玻璃缸来做10°倾斜的测试能否通过.也可通过说明书注明拿出玻璃缸前要先关电源.
! R% e* i. j& @. k6 W. t- g9 }
您需要登录后才可以回帖 登录 | 注册安规

本版积分规则

关闭

安规网为您推荐

QQ|关于安规|小黑屋|安规QQ群|Archiver|手机版|安规网 ( 粤ICP13023453-10 )

GMT+8, 2025-4-9 17:20 , Processed in 0.088494 second(s), 30 queries .

Powered by Discuz! X3.4

© 2001-2023 Discuz! Team.

快速回复 返回顶部 返回列表