|
本帖最后由 passagere 于 2017-3-31 07:47 编辑
6 M' X* H4 _% l( ?, |4 C
' ~+ \$ `% J, X1 O0 N8 ]# |7 yFor luminaires with supply cords, the arrangement of the terminals, or the length of the
( p) o! S. g* U( M6 bconductors between the cord anchorage and the terminals, shall be such that, should the cable
* I5 ]6 l! @2 s' ^# u( bor cord move out of the cord anchorage, the current-carrying conductor becomes taut before
3 n1 g* ]* `5 ]# Athe earthing conductor.
9 n. f* K# H6 h5 n: W5 x2 R( X/ f: B g! v8 u. H. M
这是60598标准原文,terminal是包括端子的,其实应该是任何连接导线的位置都可以称呼为terminal,比如常见的导线焊接于PCB上的焊点,如果非要端子才适用,有违标准本身的含义。毕竟焊接在PCB上或者固定好的连接器上的terminal,对芯线的拉扯力最强。6 f$ t/ @6 K( g6 W+ w/ a
& A" j3 Y2 ^/ X1 Z' v$ @& u# ?以下是维基百科的定义:
+ h! W T: e- I B7 N- K/ r# jA terminal is the point at which a conductor from an electrical component, device or network comes to an end and provides a point of connection to external circuits. A terminal may simply be the end of a wire or it may be fitted with a connector or fastener. 7 q. v7 u( h# L( x9 _- h4 j" N2 I
|
|