|
本帖最后由 passagere 于 2017-3-31 07:47 编辑 ) O% x5 }& b5 {, g
& g& X+ W7 K: N3 y
For luminaires with supply cords, the arrangement of the terminals, or the length of the2 M2 ?' ]# _1 c+ b3 R( z) {0 a/ j
conductors between the cord anchorage and the terminals, shall be such that, should the cable5 N( ? c* l+ \& I' e/ B% {
or cord move out of the cord anchorage, the current-carrying conductor becomes taut before6 n6 {: K1 Z. Q- o
the earthing conductor.8 ` }7 j4 z: Y5 H8 e; o( M
9 X) n/ n$ T5 V这是60598标准原文,terminal是包括端子的,其实应该是任何连接导线的位置都可以称呼为terminal,比如常见的导线焊接于PCB上的焊点,如果非要端子才适用,有违标准本身的含义。毕竟焊接在PCB上或者固定好的连接器上的terminal,对芯线的拉扯力最强。# x A5 @, k7 B) w6 U
1 ^1 w3 p( \4 A' {3 k以下是维基百科的定义:
# h) R8 u* H) G. P: _# I- `4 mA terminal is the point at which a conductor from an electrical component, device or network comes to an end and provides a point of connection to external circuits. A terminal may simply be the end of a wire or it may be fitted with a connector or fastener.
5 _( `5 R* q1 P/ a) K |
|