|
Background: OSM 2012 found it useful to have a similar decision for EN 60065 as the decision 01/8 for EN 60950-1. It has lately been questioned by the chairman of IEC TC108/MT1 that the decision 12/2 may amend EN 60065. Thus, we are proposing a revision of 12/2. Ref. OSM/EE – 2007 Item No.7.1 (enclosed):" O1 J2 G- V, i$ ]& O7 |4 Y
“OSM decision 01/8 requires markings on the product (e.g. "Use only power supplies listed in the user manual / user instruction." or “For applicable power supplies see user instruction”). Furthermore such sentences shall be in the languages acceptable to the country where the product will be used.$ z. y/ J; Y% A
We cannot assume that all people speak or understand English and therefore it is necessary to put nearly all languages of such relevant safety instructions on the product.
7 h. F! c- c8 K0 p1 W6 J) w' hThat cannot be a solution because many products are too small!”! U# z$ A- }/ a d" S) g7 A0 Y8 M: E! v
OSM/EE-2007 agreed to use instead of such instructions (sentences) on the product, international accepted symbols like these both marks (ISO 7000-0434 and ISO 7000-1641):
3 o3 i) k9 F7 YLater it was confirmed by TC108/MT1 that the book only can be used as an alternative. See explanatory notes below. Based on this it is proposed to revise decision 12/2 as amended with red text under the decision below.( u( g7 `% e+ b
In case safety of an end apparatus relies upon the power supply for general use (adaptor) to EN 60065 apparatus, the use of the specific adaptor needs to be controlled.; D1 k% X( b. G& o, \+ C# y) m4 R
The safety issues may relate to a reliable insulation, single fault conditions, heating etc.4 `$ R! }; [# K! h( W9 B
Extract of 5.4 Instructions:
; j0 r; i" B$ n* p/ cWhen information with regard to safety is required according to this standard, this information8 i! k* a) }( c W( _* r
shall be given in an instruction for installation or use and supplied with the apparatus. …
6 |5 ~* x! R& A) Z/ ?' wIt would be useful to have a similar Decision for 60065 as the Dec 01/8 to EN 60950-1.' \' ? x! }7 G
Dec 01/8 is enclosed for convenience.
2 t. t' ^1 k2 N" E4 A! H' V0 D# V# K
Decision: This decision replaces 12/2 with the amended text in red:
4 G o. m" I. F+ y1 r0 HWhen safety of an apparatus relies upon the power supply (adaptor) using a non-special connector for the a.c./d.c. input, the apparatus must have a marking stating the following: "Use only power supplies listed in the user instructions"( e. B: Q' z, x
or
# ~) L$ q; a) I3 U# F! g"For applicable power supplies see user instructions". This statement shall also be in the user-instructions." f$ f6 P5 h" U
The user instructions must then have a listing of manufacturers and models of the relevant power supplies. As an alternative to the text on the product, it is acceptable to use both the symbols ISO 7000-0434 and ISO 7000-1641. The book alone is also sufficient (ISO 7000-1641).
$ _) @' \6 o. N, V
- u2 o4 |- w3 P1 n+ ?+ K2 ^ |
|