|
本帖最后由 yangcanluck 于 2013-8-7 21:01 编辑 ) F3 F) P8 `( @9 s( [ u# R
$ f3 Y" ?, N5 ]9 |. J
最近在看IEC 62133:2012 的标准经常遇到问题,如8.3.9条款中有一段话,不是很理解还请高手帮忙分析分析。
; z: j! y# x2 p* z- QBottom surface of movingpart of the press equipment is made of Nitrile rubber or Acryl, which is put onthe 10 mm x 10 mm stainless steel shaft. The detail of pressing jigs shall beshown in Figure 2. Nitrile rubber bottom surface is for cylindrical cell test.For prismatic test 5 mm x 5 mm (2 mm thickness) Acryl is put on the Nitrilerubber. The fixture is moved down at the speed of 0,1 mm/s monitoring the cellvoltage. When voltage drop caused by the internal short circuit is detected,stop descent immediately and keep pressing jig in the position for 30 s andthen release the pressure. Voltage is monitored m-ore than 100 times per secondand if voltage is dropped more than 50 m V compare to the initial voltage, itis defined to internal short circuit has occurred. If the pressure reaches 800N for cylindrical cell and 400 N for prismatic cell, stop descent immediatelyand then keep in the position.
3 p: q6 s9 M, `
" {8 @3 r4 I% p4 D& ]1 j" X哥哥们帮帮忙!这该怎么测试呢!- R: ~% K2 s5 B6 W/ }. s
|
|