|
关于7.1章:1 ^! s b9 _8 c: q
7.1 Delete the second and third paragraphs, including the note.% ]7 i$ q. J4 S) r8 O$ a- [: r
4 p/ t8 x9 X0 l0 I
请教下到底删除的是哪些信息?是红色部分吗?EN的版本也是一样的吗,谢谢各位了. F6 a. I6 U9 i
' H6 K8 }$ r: r7 A5 m" j7.1 Cable reels shall be marked with:
; ], r4 x7 o, H$ M0 q- V' P— rated voltage in volts;
7 ]: I. }9 Q! q— symbol for the nature of supply;
% K7 t% j7 D& L1 ]— either the name, trade mark or identification mark of the manufacturer or of the vendor responsible;- P$ ^2 b0 _+ r- j4 H. z; u# y/ J
— type reference, which may be a catalogue number;
; S& m# e/ i" a3 [$ G0 M7 ]+ P— symbol for degree of protection against ingress of water if higher than IP20;( o7 F+ w: i# x/ z
NOTE The degrees of protection are based on IEC 529.
3 u+ B- b, O- T, z* i4 {— maximum load which may be connected to the socket-outlets, to be stated in watts supplemented with
. ]) Y8 j- Z& A! a( ethe voltage in volts, for fully-reeled and fully-extended conditions.
, J1 Y+ t9 I* i8 h: `EXAMPLE: “1 500 W — 230 V flexible cable fully-reeled,0 w2 h! _# H2 h* q3 S
3 000 W — 230 V flexible cable fully-extended”.8 u J; B2 P+ E0 x
: I$ S+ a7 C/ o( l0 U
Cable reels not protected against excessive temperature shall, in addition to the marking of the maximum
0 S# D# ]+ ^* i5 |allowable loads, be marked with:! F$ v+ y: u& Q5 ]! }
“WARNING — Do not exceed the maximum allowable load”.. Q2 x+ R" |1 n$ v2 {9 A% N
See Annex ZB for special national conditions and Annex ZC for A-Deviation.
+ V! x4 Q" S% N5 {9 [Cable reels fitted with a thermal and/or current cut-outs shall be marked with an instruction clearly
8 M' W. y; c5 C# w* C. p- o0 J4 hstating how to reset the device.
& N2 F& `! w! QNOTE Cable reels may additionally be marked with rated current in amperes4 u' ~4 y! S, T j; l1 [, |
) w! i! x; G# A8 d C: w/ F9 T4 C- d4 A2 N. I
|
|