|
lds08080808 发表于 2016-9-26 09:35
2 O4 r" f0 o9 ?1 p. E u! G2 A老大,是UL998,平时做美标产品少,欧标做完非正常不会重加水去评估,对美标标准理解也不透彻,所以上来请 ...
! t. R" P U$ ]2 I7 V9 H1 j65 Abnormal Operation Test2 z( @9 B& k8 `% y5 d* [' G
65.1 General
! C1 ~. E' o, P+ t$ ]65.1.1 If the conditions of normal operation are not representative also of abnormal conditions likely to be
* i+ E' v' p, u, Sencountered in actual service, the product shall not cause a risk of fire, electric shock, or injury to persons
! R) I. X6 x1 A1 S9 m2 Rwhen operated under such abnormal conditions.$ d7 C- h3 U- T5 W% A( M
65.1.2 The conditions resulting from abnormal operation of a product shall be confined by the enclosure5 P7 Z0 K+ F' i2 B" f
when the product is subjected to tests such as blocked armature in a relay, transformer burnout, stalled+ ^! l# N2 G) [5 g- @
rotor, operation without liquids, or other conditions that may be encountered in service.3 k; [: f8 o6 A @ q5 V) T
65.1.3 An electrode-type product shall be operated as described in Clause 65.1.4 until ultimate results are
. Y; y5 C5 ~" e& Uobtained. The results shall not be acceptable if a nonintegral branch-circuit protector trips during the test.6 R2 }) W& G, U* Z, l
After the test, the product shall comply with the Starting Test, Clause 55 and the Input Test, Clause 56.0 s5 w7 v, \6 B+ ?( Z
Exception: A product need not be subjected to this test if the water-level-limiting device operates for& I2 G9 t3 A( W1 D# g
100,000 cycles with no mechanical or electrical malfunction or significant pitting or burning of the contacts.
* t3 m7 k9 E$ C& }: ]2 R/ X$ R65.1.4 The product shall be mounted as intended and connected to a source of rated voltage. The drain
/ G, H$ X8 R# d5 rvalve shall be blocked closed, the water-inlet valve blocked open, each water-level-limiting device shall
1 } T9 W# P) F1 A, r, bbe bypassed, and the electrodes are to be electrically connected. In addition, the product shall be
6 U' S3 Y, z( s1 t4 Q8 \mechanically and electrically isolated from any ground means. If the hardness of the water may be a3 R4 @/ }, R) H4 Q8 \, b f
factor, the test shall be performed with a solution of 0.5 g (0.018 oz) of calcium sulfate (CaSO4) per litre
+ G/ R2 z5 B0 B9 n7 w; bof distilled water. The product shall be operated until ultimate results are obtained.) {- t' q% U% M/ l
65.1.5 A product that is permanently connected to a water supply shall be operated without water.2 x! H5 [$ t x& P" I x( `' w! T& r) w
. ?' N3 ~% m0 w: n, U+ J |
|