UL1598 对 Barrier 的厚度要求

fasten

5.4.1 A barrier shall be constructed of one of the following:
' {3 C; ^' g7 ?4 T(e) a polymeric material that complies with Clause 5.7.1.6.
5.7.1.6 A polymeric material used as a barrier shall:
' {( D' h, l# r/ j% ]- K(a) have a minimum HB flammability rating or comply with the horizontal burning flame test of
* e( e& ^5 g) ~3 Y" LClause 16.25;
(b) have a temperature rating equal to or greater than its maximum operating temperature in
0 o" _$ l$ h' G" ?  othe luminaire;
2 T$ l# g- d' ^$ b7 t! J9 ~(c) for molded or formed thermoplastic parts, comply with the mold stress-relief test of Clause
16.4; and
(d) comply with the barrier strength test of Clause 16.1.
7 o/ H9 [( K5 j# q- e
根据以上条文，是没有规定厚度但是需要满足测试要求。UL要求你满足0.71mm的厚度要求可能是还有其他条款需要满足。

kevin245

謝謝前輩, 長知識了.

fasten

lyjian 发表于 2012-8-28 09:22
谢谢，另外一个问题，我们这款是LED产品，标准主要参考UL1598和UL8750，如果两个标准对某一参数有冲突时， ...

6.1.1 A unit intended to be used in an application identified by one of the standards specified in 1.3 shallcomply with the mechanical construction requirements of that standard. If an end-use application is not specified or identified, or if a particular construction feature is not covered by the identified standard, the unit shall comply with the mechanical construction requirements of this section.
' e2 H3 J0 B8 a! @+ D4 Y1 d' W7 [- S7.1.1 A unit intended to be used in an application identified by one of the standards specified in 1.3 shall comply with the electrical construction requirements of that standard. If an end-use application is not specified or identified, or if a particular construction feature is not covered by the identified standard, the unit shall comply with the electrical construction requirements of this section.
! E$ E1 W& y1 I' e* I! u: X
1 h4 j4 `9 t6 H+ P7 e, S- Z请参考UL8750这两段条款，意思是如果UL1598等标准没有规定或者要求不一样，UL8750的机械、电气要求必须满足。也就是执行最严格的标准要求。
, P$ r7 {) A6 S3 p* f

linbaoshi

fasten 发表于 2012-8-28 10:01
2 Y4 {/ N5 f% M/ m9 m6.1.1 A unit intended to be used in an application identified by one of the standards specified in ...

误解？应该理解为如果最终产品的标准没有要求的结构，必须要符合这本标准？

hzj101988

UL 8750对挡板的要求为0.71mm

jsspace

fasten 发表于 2012-8-28 10:01
6.1.1 A unit intended to be used in an application identified by one of the standards specified in ...

) o0 o: o, b# v8 h' U5 A这句话的意思是，成品标准上没有覆盖到的，以8750为准。如果产品标准有提到的，以成品标准为准