本帖最后由 H-RH 于 2013-6-30 01:28 编辑 Q/ k" N# w2 S9 }4 Y# g' I
- D* s7 q7 Q. U
你说的应该属于 UL 982 Section 22.4 及 66.25.1 "with a stop position while energized" , h9 W6 S+ x5 `: w, U
6 j( S% h- r( _6 ^' S& w
; L8 p" o) H+ t0 M5 R4 ?! \2 V$ N22.4 If a malfunction or breakdown of an electronic component, located in any circuit of the product, results in increased risk of injury to persons, such as a loss of OFF control or unexpected operation, that circuitry shall comply with the requirements in the Standard for Tests for Safety-Related Controls Employing Solid-State Devices, UL 991. A single malfunction is to be considered at a time. 6 T7 f& M. a; x7 x
Exception: An appliance employing exposed moving parts and electronic controls with a "STOP" position, where a single malfunction of a component can cause unexpected operation, shall be provided with a motor control OFF switch in accordance with 17.4 and be constructed with a red light which flashes only when the appliance is energized and when the motor is in a stop condition but not OFF. See also 66.25 and 70.32.
7 R- e, T" j% R6 ^% W2 N. d66.25.1 Products employing exposed moving parts and electronic controls with a stop position while energized, and required to be provided with a flashing light in accordance with the Exception to 22.4: .... % d/ M$ b1 Y2 N; H3 G$ x$ E
% r( L1 l6 ], i# X( r, T2 z7 p9 \
L5 o' w2 [( u# a即电源已经启动(energized), 但操作在 stop position, 要求闪烁之红灯(red flashing light)! / `+ ? V& c5 o5 S9 T% ?5 J; S; \
在 Certification Requirement Decision (2012-01-13) 又作了少许更改, 不一定要 red light: 6 k) N1 v0 A; v
' o2 @* f4 H3 E& p# k
5 f5 Z6 n" B3 M.... shall be provided with a motor control OFF switch in accordance with 17.4 and be constructed with a light which flashes only when the appliance is energized and when the motor is in a stop condition but not OFF.
# j" O h) e" h. R/ T1 T$ \
) O, G: [1 o0 ?+ ?% e- y; x$ a |