|
刚接触到61010的标准,看了下61010的底部外壳开孔要求,第9.2.1节是否可以理解为:) d1 ?) j6 G6 s# ]4 d2 F9 f
1.底部不开孔6 N( y7 w2 Z& y1 ]/ B$ G" [+ z0 r: W
2. 开任意形状的孔,但是必须按照要求加挡板。(不管开的开长条形状孔多窄,如0.2*10mm,都必须加挡板)
( ?- x7 P) R0 H7 } 3. 如果是金属外壳的话,可以开符合表12要求的孔(孔在任何方向下的直径都不能大于表12的要求)9 n: J3 l* a0 \3 u' b
4. 或者加金属防护网
5 d; L4 h! n, l8 W" ~7 t我对照了一下实验室的仪器,发现TDS1012示波器是塑料外壳,底部有开长方形孔,而且没有加挡板也没有加金属防护网。是否表明TDS1012是不符合安规要求的?; Y$ a5 S! I- s& e- j' A
IEC61010 cl 9.2.1
6 g5 n" ^7 x3 f5 Wb) The ENCLOSURE shall meet the following requirements.
7 }% D. L# q3 D7 Y& N) ?2 _4 ~1) The bottom shall have no openings or, to the extent specified in figure 7, shall be1 F4 }' |+ _' F" l$ e2 Y
constructed with baffles as specified in figure 6, or be made of metal, perforated as
+ ^: `5 u$ A1 R; ispecified in table 12, or be a metal screen with a mesh not exceeding 2 mm × 2 mm
4 I M; h4 Z6 S; [: ], a& l5 U* hcentre to centre and a wire diameter of at least 0,45 mm.9 s r& n- V3 s* I2 M: i4 C9 x
UL的要求也一样。7 p0 A* Y0 P+ q2 O9 T
GB4793的9.2.1的要求
6 d9 i8 S/ R7 @; I: Z/ vb) 外壳应当符合下列要求。
p" W" {% E. n6 @1) 外壳底部应当无开孔,或应当在图7 规定的范围内装有符合图6 规定的档板,或应当用金
% _7 W8 P, N3 e; |4 D属材料制成,开孔符合表12 的规定,或应当是金属隔离网,其网眼中心距不超过2mm ×
* G A1 g) B" `+ S7 I, n2mm,金属丝直径至少为0.45mm。 |
|