|
60335-1的第20章测试,标准叙述如下:( Q l+ C. h% m. Z" Z! z1 S- ^
The appliance is placed in any normal position of use on a plane inclined at an angle of 10 to the
( [6 c5 r+ I9 \. Xhorizontal, the supply cord resting on the inclined plane in the most unfavourable position.
1 K& p, E Q7 x% K. q However, if part of an appliance comes into contact with the horizontal supporting surface when 6 {4 ? ]/ R4 Q7 x0 p
the appliance is tilted through an angle of 10, the appliance is placed on a horizontal support and
2 v! X: X: \" _3 @: A, @2 ntited in the most unfavourable direction through an angle of 10.
& Y8 O: P# X( c- d5 m' E上述意思是,将产品放在一个与水平面有10度倾角的板子上,电源线以最不利于的方式放在这个板子上.如果,appliance倾斜10度后任意一个部分接触到水平面,那么测试方法是将appliance放置在水平面上,以最不有利的方向倾斜10度这样测试
- V' u0 m2 K, j: p4 K8 ~这样的话,只要appliance有支架,角轮等等,即只要底面不是平的,倾斜后肯定外壳等等先接触到水平面,都执行hower 后面的测试么?
/ t2 z% q$ z; z f; r0 V9 C我的理解有问题么?另外,其实有支架的appliance也可以放在倾斜10度的板子上啊?放在上面,可以让
. j+ ?# Z$ m2 Y2 c8 Eappliance的各个部分不接触到水平面啊,为什么所有appliance不采用一种方法? |
|