|
关于ETL logo的大小问题, 我发邮件问了ITS那边,他们给我回复了, 我摘抄了其中的一段话出来:
3 j7 c6 }) c3 C- E9 i4 {• You may enlarge or reduce the Mark proportionally,
( P* Y! ~' h$ S- n' Y: R2 Obut it cannot be changed in any other way. Care
# @4 R$ K8 g$ P% X" D) }should be taken when printing a Mark on a
4 y3 ?* A+ Q1 Xproduct, this should be as large as the space will
8 }+ f4 A: b9 l5 V, M1 i/ Oallow, typically above 13mm wide (0.5”). Printing& w( i. X `" @& m' P& g* x6 W5 {
of smaller sized marks is allowed, but all parts of; p. O+ F+ N5 N3 r
the mark must be clearly legible when viewed
3 x* e" E& ^: X; x8 Jon the product. The registration symbol, ®, or! d2 \3 q# }" Z5 B# {) H+ b6 Q
CM (where applicable) must be visible. In special
2 C* q8 ]0 J2 S6 @circumstances where the physical size of the+ F/ h2 c' x* {( B
product means that this is not possible then you
6 `. R! g( m+ x- l: Vmay apply for authorisation to use an alternative, y5 }% q/ G6 a0 I1 h
“small variant” of the Mark, obtainable from your
; {0 }" C3 F( k3 b& Tlocal certification office. On literature, the minimum
b7 `7 Y1 M- G# Z% K7 csize of reproduction should be 25mm (1”) wide. |
|