|
关于ETL logo的大小问题, 我发邮件问了ITS那边,他们给我回复了, 我摘抄了其中的一段话出来:; _% Z8 |) I# Y5 t5 h- }4 m
• You may enlarge or reduce the Mark proportionally,
0 y. J+ _" H, L" h7 Dbut it cannot be changed in any other way. Care/ T2 C6 `1 k# x' u s5 l& j F
should be taken when printing a Mark on a& G" p, L4 ]8 ^& |1 V% y
product, this should be as large as the space will
7 S L( ^ L: R' r! Iallow, typically above 13mm wide (0.5”). Printing
4 B, V3 ?5 b. Z6 M$ \of smaller sized marks is allowed, but all parts of( v$ c; b- U5 k
the mark must be clearly legible when viewed% a1 H% o; u* u
on the product. The registration symbol, ®, or
( D& `; n" L/ L- q, ~$ HCM (where applicable) must be visible. In special g0 t" Z2 M" S) x& h% ?2 z d0 y3 k+ R
circumstances where the physical size of the, l) G4 M {' L u
product means that this is not possible then you
9 f; A1 a+ P, ?/ _8 i8 o% Fmay apply for authorisation to use an alternative- L$ h. L; M! v. E; ~& B4 z* B/ R
“small variant” of the Mark, obtainable from your( O* L8 w0 G& @: N, i* P/ c# S
local certification office. On literature, the minimum
: N2 _. z" ]1 Z1 v0 `size of reproduction should be 25mm (1”) wide. |
|