|
刚接触到61010的标准,看了下61010的底部外壳开孔要求,第9.2.1节是否可以理解为:% y5 q9 K$ }2 l: u& B& R
1.底部不开孔8 M, s9 }" ?+ ]8 ]! c" [, g
2. 开任意形状的孔,但是必须按照要求加挡板。(不管开的开长条形状孔多窄,如0.2*10mm,都必须加挡板)$ q( c. ]* @6 Z
3. 如果是金属外壳的话,可以开符合表12要求的孔(孔在任何方向下的直径都不能大于表12的要求)
) u9 g6 l& R4 T& s( w% J! D 4. 或者加金属防护网
* Y6 b% _3 p, H( U8 o3 a7 O我对照了一下实验室的仪器,发现TDS1012示波器是塑料外壳,底部有开长方形孔,而且没有加挡板也没有加金属防护网。是否表明TDS1012是不符合安规要求的?/ H) X$ H0 |7 |3 {0 G. I- C- R
IEC61010 cl 9.2.1
# W! ~4 G% t9 ]2 p8 N4 x/ ]b) The ENCLOSURE shall meet the following requirements.
8 V/ Y: z, g1 K( l2 f9 |# p8 c0 p1) The bottom shall have no openings or, to the extent specified in figure 7, shall be
F4 z @: Y; X) C" Vconstructed with baffles as specified in figure 6, or be made of metal, perforated as
. E. p) e% B3 K3 A* t; ]specified in table 12, or be a metal screen with a mesh not exceeding 2 mm × 2 mm( t; ^* P5 D* d D
centre to centre and a wire diameter of at least 0,45 mm.7 A9 R1 q" q0 Z1 E" r
UL的要求也一样。
; l/ _" h( J+ d' V* ~3 ]GB4793的9.2.1的要求" C8 j7 J' k4 ^6 x
b) 外壳应当符合下列要求。
% u$ C. d) }8 Z; _# t, {7 f: d1) 外壳底部应当无开孔,或应当在图7 规定的范围内装有符合图6 规定的档板,或应当用金
2 K- L8 p0 c4 F8 A属材料制成,开孔符合表12 的规定,或应当是金属隔离网,其网眼中心距不超过2mm ×
8 _- g3 t" ]& i; O* }6 R2mm,金属丝直径至少为0.45mm。 |
|