|
不错,答复得挺详细。) D9 D2 @, g6 n; z& O# V& R( B
3 ]6 E0 V8 o2 F( ], K' ^! X
“此电源在此额定电压下的内部阻抗为3欧,如果没有3欧,则要外接电阻,否则有可能烧坏待测设备。“如何理解?
" j" B5 n( b& ]对于普通的电源为何还要定义内阻?出发点是如何考虑?
, n0 _: `% s* c, [& C8 J7 }- J7 v9 T* x) m5 k" V1 H
7 i: u* G0 A# [. h/ q2 Z% {3 n
0 H! [" u) H) L+ K) |5 \5 j5 t* Q
引用第7楼ljh809809于2008-10-02 12:53发表的 :
3 g, x* g8 {1 q8 v; U我的观点:
1 a, ~7 |. L! u5 a$ D. O1. 此设备可以认为接supply apparatus for general use.
: t' g) X8 i$ Q# |# I0 q做正常温升时,根据cl 4.2.11 of IEC60065, table 2.
6 q) `* L9 Z0 n此设备的额定输入电压为5V d.c., 由于表中只有4.5V 和6V,而不能用插值法,故取6V额定电压,我们取与6V额定电压对应的标称空载电压9V(nominal no-load voltage), 这是根据标准中:The values of no-load voltage given in table 2 are subject to the under-and -over-voltage prosions specifed in 4.2.1. 那么做正常温升测试时的上下限电压分别为9 x 1.1=9.9V, 9x 0,9=8.1V. 值得注意的是,此电源在此额定电压下的内部阻抗为3欧,如果没有3欧,则要外接电阻,否则有可能烧坏待测设备。) N; U/ p& y! b0 B
做非正常测试时,根据4.3.15: using a test power supply as specified in table 2 step by step upwards, startign with the value one step above the value specified for the rated supply voltage of the apparatus under test.
2 A4 w5 ]; U$ R....... |
|