|
我们的VDE插头测试失败,插销尺寸不合格,郁闷!
{& r1 V8 K% ?2 F2 i4 V; `经多次联系,VDE工程师发了一份东西过来,无签名无公章,应该算是内部管控标准。5 N$ Y7 W" ~6 T! I: j" n" d
发上来让大家看看,参考一下吧!. J4 k; a9 @/ W0 {5 v& `) g
- V3 T |" A/ j8 ]1 @
Old requirement: Apply the radius gauge 2,5 or 2,0!
" M% \: }" W% J( _4 y
) k' N6 E/ J. ZNew requirement: : b' h: n# L' ~, v! A0 [, v! b' c4 n
If the diameter of the plug pin is 4,8 +/- 0,06 than we will apply the following radius gauges: 2,25 or 2,5 or 2,75- g) {- n$ ], U2 I& R- X9 ] T1 Q
If one of them can apply on the plug pin, the requirement is fulfilled!/ {" c" o) v, l4 t' Y+ m; b7 ^; o
# T# y4 S# _% Z: v. u( L
If the diameter of the plug pin 4,0 +/- 0,06 (for example flat European plug) than we will apply the following radius gauges: 1,75 or 2,0 or 2,25 9 h- T& ~) m" [$ l" G" A' Z
If one of them can apply on the plug pin, the requirement is fulfilled! |
|