DSH 561 Electronic thermostat

小米

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

DSH 561

Electronic thermostat ! e# A. t( ^; R2 ]

24

60730-1(ed.3)

" Z7 t6 Q$ `( z! G0 R1 @" EQuestion:
In an electronic thermostat a capacitor is placed across reinforced insulation between the line 230 V and SELV circuit. According to the manufacturer's information the use of this capacitor is necessary for the correct operation of a switching transformer which supplies the same SELV circuit.
In IEC 60730-1:1999 (EN 60730-1:2000) there are no specific requirements that cover this situation. In clause 24 "Components" of IEC/EN 60730-1 capacitors are only evaluated in respect to their use as RFI suppressors. Conformity to IEC 60384-14 is required without any additional indications.
" S% z. ^% p. H+ ~) N! VWe noted that IEC 60065:2001 and IEC 60950-1:2001 have requirements for capacitors bridging insulation.
- j. r& E# p+ P- f1 oIn particular:
# ]3 S2 ]1 L% r% |  GIEC 60065:2001:
$ i# }9 m6 R& U  m/ K# M8 s- 8 "Constructional requirements with regard to the protection against electric shock", subclause 8.6;
- 9 "Electric shock hazard under normal operating conditions", sub-claue 9.1.1;
- 14 "Components", 14.2 Capacitors and RC-units, sub-clause 14.2.1 b).
IEC 60950-1:2001
6 E# n3 m3 J- Q- 1.5 "Components", 1.5.7 "Double insulation or reinforced insulation bridged by components", 1.5.7.2 "Bridging capacitors" and 1.5.7.4 "Accessible parts";
6 N% I+ W  `9 k  P. M9 z& @1 a  n  C- 2.4 "Limited current circuits".
: T6 i# h/ H1 q$ XAccording to both these standards in this case a Type Y1 capacitor or two Type Y2 capacitors in series are required across reinforced insulation.Is it possible to take into account the same above mentioned requirements for automatic controls falling into the scope of IEC/EN 60730- 1?
4 t2 E5 y/ r5 n* R, a7 q2 v6 ]3 pDecision:
* q* g3 f) x$ W9 y( wFor an electronic thermostat in which a capacitor is placed across reinforced insulation between the line 230 V and SELV circuit, it is acceptable for two Type Y2 capacitors (according to IEC 60384-14) in series to be used.
- ~" Q0 F! W) `6 C+ A& ^The safety level shall not be less than that required for "protective impedance" according to subclause H.8.1.10 and H.11.2.5 of IEC 60730-1:1999.The overvoltage category of the equipment in relation to maximum voltage of the capacitors shall also be taken into consideration. The controls shall be declared to be installed in overvoltage category II or less.


5 E4 a# V2 c1 J/ i