电吹风19.2的测试

一行白鹭上青天

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

         各位前辈，我想请教一个问题，就是吹风机19.2的测试条件：
6 ?' v' F+ H. r9 z8 K( `- t+ W( g
! m: B% T5 Z5 ?3 M19.2 Addition:
Restricted heat dissipation is obtained as follows:
– motors are disconnected;
– hand-held hairdryers are placed on the floor of the test corner in any stable position
likely to occur;
, i6 m6 G4 l  v– appliances intended to be filled with water are operated empty;
– hand-held appliances without an integral rest are placed on the floor of the test corner in
any stable position likely to occur.
Hairdryers having a flexible hood attachment are also tested with the motor operating, the
airflow through the hose being restricted to give the most unfavourable result.
+ H8 |% m& \( T/ Y* t4 MHeaters for detachable curlers are placed on a piece of low-density glass-fibre insulation
having a coefficient of thermal insulation of approximately 2,5 m2K/W.

   这些条件是独立的做多个实验 还是同时满足做一个实验？
( F' k5 u2 N# [, M7 {
$ s. S- \8 l; v! U# B8 n* j请大家指点，谢谢。
/ N8 c& Y/ C* r; g8 K. W

lotte_528

是一个测试，如果分开模式测试的话标准会进行说明，例如IEC 60335-2-25的19.103：
19.103 Appliances are operated under normal operation and with any single fault condition
# t6 n6 K# l4 k# r% Z& Tsimulated that is likely to occur. The controls are adjusted to their most unfavourable setting
and the appliance is operated for the maximum time allowed by the timer or 90 min, whichever
is shorter.
3 Q4 C! v4 R) M! N- I! I* T- a6 s5 _( HNOTE Examples of fault conditions are
' d& P3 l0 v5 g1 g1 S: x- A7 X3 B– blocking of air openings in the same plane. This fault condition is not applied if the appliance is a built-in appliance;
– locking the rotor of motors if the locked rotor torque is smaller than the full load torque;
4 c; \8 _1 K; T$ s, @– locking moving parts liable to be jammed.
0 l5 F) g2 u6 c: [9 ]还有60335-1的19.11.2：
19.11.2 The following fault conditions are considered and, if necessary, applied one at a
: `5 J! ?; Z2 ^8 _* T/ stime, consequential faults being taken into consideration:

lotte_528

是一个测试，如果分开模式测试的话标准会进行说明，例如IEC 60335-2-25的19.103：
19.103 Appliances are operated under normal operation and with any single fault condition
simulated that is likely to occur. The controls are adjusted to their most unfavourable setting
and the appliance is operated for the maximum time allowed by the timer or 90 min, whichever
is shorter.
NOTE Examples of fault conditions are
4 I  P. u3 [& |% C! w5 t– blocking of air openings in the same plane. This fault condition is not applied if the appliance is a built-in appliance;
– locking the rotor of motors if the locked rotor torque is smaller than the full load torque;
$ M# `' Z" v0 R# S) K– locking moving parts liable to be jammed.
( t2 q3 _: L& w" j1 J) k还有60335-1的19.11.2：
1 L* C0 j5 s3 }( O9 T6 A3 a19.11.2 The following fault conditions are considered and, if necessary, applied one at a
. m" n9 G4 g% |) l9 |( rtime, consequential faults being taken into consideration:

bub02

每个单独试验吧，都应符合吧，我这么理解的

一行白鹭上青天

okjun 发表于 2020-11-5 10:37
当然是一个测试。

5 w7 v9 @6 [6 Z) c8 h1 |! [谢谢，最近见识了一条一个测试的。。。

okjun

当然是一个测试。