|
head0819 发表于 2016-11-16 11:43 ![](static/image/common/back.gif)
+ `9 `) _" r6 J# m p) R% A/ M你把标准截图上来啊! 8 I# t4 `& _" T. {- r0 l
41 Test for Limited-Voltage/Current Circuit Transformers
9 d( G# e" g, @4 P41.1 A transformer intended to power a limited-voltage/current circuit shall be tested as described in 41.2.
: o2 T* `( J4 V2 x' d! E41.2 The maximum volt-ampere output capacity of the secondary winding is to be determined as follows:
* w, q) ]; S8 ^+ h9 y# eAt room temperature, the primary winding of the transformer is to be connected as intended in the0 F6 i! d: o* F3 F. D- G. @
equipment and the secondary winding in question is to be connected to a variable resistance load. When
% u8 g F1 N) C* f. oa fixed-series impedance or regulator circuit is relied upon to limit the output, that impedance or regulator
R k ]* `1 d4 K0 n9 V7 L4 vcircuit is to be included in the circuit during the test. A multiple-winding transformer is to have one: q E% r, ~% r! b, b! ]# Z
secondary winding tested with all other secondary windings open-circuited, and is to be allowed to cool to
+ s# f( f3 H/ A# s w0 V$ u1 uroom temperature again before another winding is tested. A primary winding is to be connected to a
2 ]+ M \5 \# j3 O8 C7 P% Xsource of rated voltage. The load on the secondary is to be varied in 10 increments from open-circuit to
7 w3 S, K* T h8 @! D, W* ishort-circuit condition in 2-1/2 minutes. For each step or increment in the resistance, the product of the
- U/ M- Z( v! {; M; G U2 W- Routput voltage and current is to be recorded, plotted, and run as a smooth curve. The peak value obtained
' T/ d1 a9 g: Q% c' cfrom the curve shall not exceed the volt-ampere value specified in Table 27.1. When two or more) i( A/ Q7 g* O4 n
secondary windings supply interconnected circuits, the sum of the outputs of the windings in question shall, u. n7 a: \2 N1 R
not exceed the values specified in Table 27.1.
; l) ?- Y6 X/ f' ~2 n7 N9 n. R9 }: s8 X: J9 q2 B# L5 ?; Z9 z: x7 H
做舞台灯的大部分都在广州及花都,2010-2012年间有多少家的舞台灯具被我拆的七零八落呢? |
|