|
引用第0楼yearl于2011-10-09 08:00发表的 29.3的要求适用于导线吗? :
6 P: F/ P9 o! a4 L* V29.3中关于绝缘的要求适用于导线吗?如对护套绝缘层厚度的要求。 有三种方法判断:: F4 G% {/ z/ u, p$ I
29.3 !Supplementary insulation and reinforced insulation shall have adequate thickness, or have a sufficient number of layers, to withstand the electrical stresses that can be expected during the use of the appliance. Compliance is checked by – measurement, in accordance with 29.3.1, or by – an electric strength test in accordance with 29.3.2, if the insulation consists of more than one separate layer, other than natural mica or similar flakey material, or by – an assessment of the thermal quality of the material combined with an electric strength test, in accordance with 29.3.3. and, for accessible reinforced insulation consisting of a single layer, measurement in accordance with 29.3.Z1. !29.3.1 The thickness of the insulation shall be at least – 1 mm for supplementary insulation; – 2 mm for reinforced insulation. 29.3.2 Each layer of material shall withstand the electric strength test of 16.3 for supplementary insulation. Supplementary insulation shall consist of at least 2 layers of material and reinforced insulation of at least 3 layers. 29.3.3 The insulation is subjected to the dry heat test Bb of IEC 60068-2-2 for 48 h at a temperature of 50 K in excess of the maximum temperature rise measured during the test of Clause 19. At the end of the period, the insulation is subjected to the electric strength test of 16.3 at the conditioning temperature and also after it has cooled down to room temperature. If the temperature rise of the insulation measured during the tests of Clause 19 does not exceed the value specified in Table 3, the test of IEC 60068-2-2 is not carried out." |
|