是不是现在能效认证关闭了,

打死一个人

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

请问一下大家,现在有的人在说到美国的能效关闭了,想确认一下是不是真的

在多的画面

UNITED STATES ENVIRONMENTAL PROTECTION AGENCY WASHINGTON, D.C. 20460

% {# g3 e( ^4 e1 Z5 Z; H2 _# Z% e             OFFICE OF
& s6 L1 N* f7 i/ h6 L, }             AIR AND RADIATION
8 H1 q% D* ?6 E2 _) T) L2 o$ R) ?JULy 19, 2010
* p+ \" r2 _' b9 vDear External Power Supply (EPS) and End-Use Products Using EPSs Stakeholders:
The purpose of this letter is to inform stakeholders of the U.S. Environmental Protection Agency’s (EPA) decision to sunset the ENERGY STAR. programs for EPSs and End-Use Products Using EPSs. As proposed in the May 2010 communication, these two ENERGY STAR programs will be sunset effective on December 31, 2010.
+ d# Z; U! F: c# aEPA wishes to thank stakeholders who submitted comments on EPA’s sunset proposal. Each comment was considered carefULly and will be reflected in the Stakeholder Comment-EPA Response Summary, which will be posted to the ENERGY STAR Web site shortly. While EPA appreciates the interest expressed by some stakeholders in preserving their ability to continue to take advantage of the ENERGY STAR label, the stakeholder feedback was relatively limited and did not provide compelling information contradicting the rationale to sunset. As noted in the May 26, 2010 letter, the following factors contributed to EPA's decision to sunset: 1) relatively high ENERGY STAR market penetration; 2) existing U.S. federal minimum efficiency standards for EPSs; 3) diminishing scope of the End-Use Products Using EPSs program because of new ENERGY STAR product specifications, such as small network equipment; and 4) ability to maintain and add EPS requirements to the existing suite of ENERGY STAR product categories.
; F- z7 N# o9 C3 V  g  u( rOf note, it is EPA’s intention that current ENERGY STAR product specifications with requirements for the use of an ENERGY STAR EPS (e.g., computers, displays, televisions) will be changed to require a Level V EPS as designated under the International Efficiency Marking Protocol, which is consistent with ENERGY STAR Version 2.0 EPS performance levels. Information about the Protocol will continue to be available at www.energystar.gov. For applicable product categories, these changes will occur as part of the specification revision process associated with enhanced testing and verification requirements. Also, EPA is exploring potential changes to the ENERGY STAR Battery Charging Systems (BCS) specification to broaden eligibility to certain product categories currently covered by the End-Use Products Using EPSs program (e.g., cell phones).  
1 @* D) G6 A0 k/ N% K: Z8 lImportant dates and actions for EPA and stakeholders leading up to December 31, 2010 are provided below.  
/ c3 R+ X# w- F/ H  a( {, gKey Dates:  Key Actions:
July 26, 2010
% c- ^6 l+ ~0 x, h No new Partnership Agreements for EPSs and End-Use Products Using EPSs will be accepted by EPA as of July 26, 2010.
. R, F6 M$ o2 R- bJuly 31, 2010
No new qualifying product information will be accepted by EPA as of July 31, 2010.
/ s1 Z% J9 H9 \1 S( Z' A+ {  vDecember 31, 2010
EPA will continue to recognize EPSs, End-Use Products Using EPSs and their manufacturers at www.energystar.gov until December 31, 2010.
Manufacturers must stop using the ENERGY STAR name and ENERGY STAR mark or EPS graphic in association with all products manufactured on or after December 31, 2010. (Qualified products manufactured before that date are allowed to carry the ENERGY STAR mark or EPS graphic on their packaging and product literature, as applicable. Retailers and distributors will be allowed to sell off their existing inventory.)
No new promotional materials for EPSs and End-Use Products Using EPSs (printed and electronic) featuring the ENERGY STAR mark or EPS graphic may be produced after December 31, 2010. (Manufacturers are allowed to use up existing printed material, including packaging, in order to minimize waste.)
7 G8 z( A& W- F5 H" Q To minimize the cost of labeling changes and be in compliance by December 31, 2010, manufacturers of EPSs and End-Use Products Using EPSs may remove ENERGY STAR references on websites or in other collateral materials as these materials are reprinted or changed in the coming months