|
现在我担心的是我们产品本体上有A1234,包装的标签上改为A-1234.细则上也是A-1234,包装与细则一致,但本体上的也细则不一致.这样会不会有问题,还是只要在一个地方的标识与细则一致就可以了?
, a) K7 Y# d, k% f b) Y因为细则上是这样写的:
7 ~7 W( A5 k. F L$ `7 y) J( eThe required Markings may be displayed in any of the following locations:
1 Q: x- d6 ~2 B& S/ w
& L, m) Z. b$ |& n$ g2 A F A) On each part.
% u8 J9 @) _3 G4 X( U# C' ] B) On the specification sheet packed with each shipping carton.$ g- @6 L" H1 H* W; e3 \! ]
C) On each shipping carton.+ p, h7 i7 I) s. x5 D
D) It is not necessary (but recommended) that all the required Markings appear at the same location.4 y! C5 \ J( o! w
按这段话理解,是说出现在任何一个位置都可以.那是不是相当于有一个地方一致就可以了?涉及到的模具多,费用也高.不敢轻易做决定.想听听各位大虾的意见. |
|