Magnet Wire漆包线申请UL

sabrina

广东安规检测
有限公司提供：

小型摆管淋雨试验机

IPX5X6X7喷水试验机

1000L恒温恒湿箱

各种试验指现货

可程式恒温恒湿试验箱

水平垂直燃烧机

自动卷线器试验机

耐划痕试验机

各种灯头量规现货

灼热丝试验机现货

GB1002插头量规

IPX1-X7淋雨现货

IEC61347/UL935镇流器热试验箱

灯具防风罩

IK冲击试验机

UL498插头插座量规

VDE0620插头插座量规

稳定性试验台

家电温升测试角

针焰试验机现货

热电偶焊机现货

家电125mm试验指

E12灯头量规

无绳壶无绳电熨斗插拔寿命试验机

IEC60335试验指甲

Magnet Wire漆包线申请UL时使用的标准是什么？
7 _1 E8 [+ S$ G  r$ ]
此Magnet Wire要求申请UL后的CCN值为OBMW2

wwnw_007

Systems of Insulating Materials - General
( }/ L# f1 G# z3 `; G+ e) S: b5 ~5 VUL 1446

1 Scope
1.1 These requirements cover test procedures to be used in the evaluation of Class 120(E) or higher electrical insulation systems intended for connection to the low voltage side of the distribution network where the voltage is limited to 1000 V or less and where the thermal factor and not transient overvoltages or partial discharge is the dominating aging factor. These requirements also cover the investigation of the substitution of minor components of insulation in a previously evaluated insulation system and also the test procedures to be used in the evaluation of magnet wire coatings, magnet wires, and varnishes.

. ~/ i0 d7 ?  q! q7 _8 N* }
" Q) L( C6 \6 E% _5 `$ x# l1.1 revised January 30, 2008
1.2 These requirements do not cover a single insulating material or a simple combination of materials, such as a laminate or a varnished cloth, printed circuit boards, or planar transformers.
' L% I) u4 ], @
( L: j' M2 N8 q0 x1 r1.3 These requirements do not cover insulation systems exposed to radiation or operating in oils, refrigerants, soaps, or other media that potentially degrade insulating materials.
; s* J8 W' C/ s# B9 j
1.4 These requirements shall be modified or supplemented as determined by the applicable requirements in the end-product standard covering the device, appliance, or equipment in which the insulation system is used.
7 f0 t$ ~/ c9 ^9 z
, C0 y9 T: A: S2 I* P4 t# _% |- FTable of Contents for UL 1446                                                   
3 b! F5 ]$ e8 i* o: i4 s9 S
( L% f1 V# x- v( A8 d: @------------------------------------------------------------------------

" p: S8 B- g* {) t
Cover
! L6 q# E) B; M: d9 w4 t- xTransmittal
Table of Contents
( _6 L1 X& G+ @Body
8 p9 p& K' ]6 W4 X/ _INTRODUCTION
1 Scope
2 Reference Publications
3 Units of Measurement
% Z6 m0 w/ p: O0 W+ p, n8 G4 Glossary
2 t6 ]' X! |7 e/ ]. Q0 f, XPERFORMANCE CRITERIA
5 Magnet Wire
5.1 Magnet wire coatings
5.2 Magnet wire evaluation
; j; T4 E1 V. k; L- `  f) O# j6 Varnishes
, {6 N2 T, |7 p7 Insulation Systems
7.1 General
7 d" y# J8 s8 \7.2 System components
. Q% ~7 T$ E! ^+ T% K) d8 Substitutions or Modification to an Insulation System
4 z6 v: A6 X# q2 [% U8.1 General
) k* `4 Q( X  @2 K& u; m; D8.2 Minor components
6 c% c$ ^) V. s8.3 Magnet wire
2 |) Y8 y: T, }) @8.4 Varnish
* S+ \! M. k3 t2 l! l  m8.5 Encapsulants, ground, and interwinding insulation
- u3 A4 N: Z  ?  w3 P& `! ^, aPERFORMANCE TESTS
, r" ?7 _1 R: y$ X. L! d# E" u0 R9 Magnet Wire Coatings/Magnet Wires
' [2 p# n+ f5 o+ x10 Varnishes - Thermal Aging
$ b; o4 A  i  \6 N! U11 Insulation Systems -
11.1 General
11.2 Samples
11.3 Exposures
11.4 Diagnostic tests - determination of end of test-life
11.5 Analysis and evaluation
& c* u+ M5 L$ X5 M12 Insulation Systems -
12.1 General
/ u, l' P' P" i3 _12.2 Samples, exposures, and tests
12.3 Analysis and evaluation
13 Insulation Systems -
13.1 General
: Z4 r8 D3 T' A7 [% m+ c13.2 Samples, exposures, and tests
( \) m) O0 n! I! S13.3 Analysis and evaluation
. p& S7 Y; ~$ h3 S14 Sealed Tube Testing
14.1 General
5 x. N! @( I' ^! [14.2 Samples
/ v8 ?) p  g+ O' C, h! j9 j7 A0 E, I14.3 Conditioning
14.4 Interpretation of results of non-bondable wire
) u! J4 P6 `# S( ^6 h14.5 Interpretation of results for bondable wire
* P% l5 Q2 r2 a15 Infrared Analysis Tests
MARKING
16 Details
2 p2 e. z% L/ w+ l( `0 T2 EAppendix A - Information for Magnet Wire Substitution
6 D- D; X/ q0 N+ f+ S9 r( ]Superseded List

maisie

要查询产品的UL标准号,可通过如下步骤:
3 R3 q) s# I+ q
1. 进入www.ul.com的certification目录
2.在Product Catugory Code后方框内输入CCN
3.选择任一已获得UL认证的UL档案号
4.点击See General Information for Systems, Electrical Insulation - Component
5.在下方可获悉所使用的UL标准号

sabrina

UL 1446
' B3 p3 X9 P! d2 y是绝缘系统的标准，由此判断绝缘系统的等级，
- z- N% Z$ u0 ~% x, U  D' o
不会是漆包线的检测标准吧

sabrina

呵呵..
; Z1 u/ R7 h( V( o# w还真是UL1446，
REQUIREMENTS
The basic standard used to investigate products in this category is ANSI/UL 1446, "Systems of Insulation Materials - General."

8 h' B7 s) ~* Y. k! _$ t谢谢

wwnw_007

引用第3楼sabrina于2009-02-18 14:16发表的  :
UL 1446
4 d, @8 [6 `# y* V是绝缘系统的标准，由此判断绝缘系统的等级，
0 U7 k6 m9 j5 ]- A5 y
/ u3 |9 V8 N$ i7 }不会是漆包线的检测标准吧

漆包线不是绝缘系统电线吗？那么如何进行绕组呢？绕组线间如何绝缘呢？