|
UL778中的Dielectric voltage-ithstand:, K+ ?- u* ~, [5 q5 x' x
35.1.1 A pump shall with stand for 1 minute without breakdown the application of a 60-hertz, essentially sinusoidal potential:; P7 W5 O- ]/ J7 Y2 h' p- C* N: T
a)Between live parts and grounded dead metal and) O& r y2 W1 W# |( e5 X
b)Between the terminals of a capacitor used for radio interference elimination or arc suppression.The test potential shall be as follows:' d4 A) A: j5 l' N$ _
1)One thousand volts for a nonsubmersible pump rated no more than 250 volts, and no more than 1/2 horsepower(373 watt output)./ T+ |! M- q* @/ s4 b( Y9 [* J. D( _# O
2)One thousand volts plus twice the rated voltage for a nonsubmersible pump rated more than 250 volts, or more than 1/2 horsepower. \& D) p; T% ?1 h
3)One thousand volts plus twice the rated voltage for a submersible pump., K8 @0 ?7 D8 c1 N1 T7 d
9 X6 a7 H( l: Y) z8 h, z0 U35.1.2 The required test potential may be obtained from any convenient source of sufficient capacity at least 500 volt-amperes capable of maintaining the potential at the required test value except during breakdown.The voltage of the source is to be continuously variable.! c3 K3 S' N6 r
Exception: A 500 volt-ampere or larger capacity transformer need not be used if the transformer is provided with a voltmeter to directly measure the applied output potential.
: ]) z* L" L5 k7 o" s4 r& J$ N. ^$ L$ F* |2 [! J' j# I& p7 V
35.1.3 In the case of a DC pump, the test potential is to be direct current.: l0 a' G3 I( W# D7 t+ M
. N; t( D! y5 y2 \, J( Y' \" l1 I
看的不是很明白,那位高手幫忙指點指點。 |
|