|
本帖最后由 chinatown 于 2017-1-6 13:48 编辑 / e' F. f5 u9 e' Q
3 V3 U: P+ I2 o$ f; q$ g1 RIEC 60216-4-1 is a standard providing requirements for ovens for aging tests and requires forced gas3 X, h% F! w: }, k
ventilation. As the ball pressure test is not considered to be an ageing test such forced gas ventilation/ Z' k l+ C1 Q* E
is not required and should not be confused with forced convection.
9 i! m3 F7 _- c" t9 z, jFor the purpose of ball pressure testing chambers with or without forced convection may be used,
7 v6 T; W& G4 z. ^& E0 gprovided all other requirements are fulfilled.1 x) \$ z4 v3 t
Following clause 5.2 of the standard and considering the note there, a separate thermocouple on or
+ u: T) G' f- ?6 Z5 Y7 T+ kright below the surface of the test specimen support and as close as practical to the test sample shall" Q/ {9 t. d9 n8 H
be used to check that the temperature of the test specimen support does not significantly deviate from
* V% U; j% Y. [' bthe test temperature.( E9 |. U) o# g# B+ y) l
In addition measure the air temperature as close as possible to the test specimen. Z7 ?% b$ ]( ~4 p# r' L
In case of non-round indentation obtained, report the biggest diameter measurement observed. The
3 Q' G X1 x: [. w7 \& Omaximum difference between the longest and shortest measurement should not exceed 0,2 mm.) ]9 A3 F; A- N o9 T' j
Where the product standard contains differing or conflicting requirements to IEC 60695-10-2 or to this8 \& ?0 @. Q8 e5 Q% w/ `: @
decision sheet these product standard requirements override the requirements from IEC 60695-10-2
" u9 N0 R4 Z/ @, W. Y) ]and this decision sheet.) B7 m& G" |9 |( [
; B; P0 y/ U8 k0 T2 c
" B) b$ a1 l; G% c7 ~' b! ?( w
( p$ q8 {7 }! z+ ?( C, Z
: ]: O4 `6 A. N( ~; ?
& y6 p5 n9 V# x$ o7 s! _
3 ~, h1 B6 R+ h2 T" b |
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有帐号?注册安规
x
|