|
大家能否讨论下各家做60335-2-29 电池充电器带载到底是否要求一致:' ~/ e: k# t1 e1 p e- g" S0 }, G
充电器可以给锂电池及铅酸电池充电,输出超过20VA,是否输入和温升都要分别带载101网络以及最大容量电池测试
1 O9 j4 P) H, B9 ~( ~, K另外3.19里面说的Other battery chargers 是指哪一类电池,这个理解也有不同6 c" J3 X% a) T/ I S( N% G
据我了解 每个实验室要求都不同,所以还是有讨论的必要的:(
" ~, P! }- j& ^- r% l- s+ q" p" s g( U: ~1 w" {( |
" L: M. C6 f8 r+ O/ u! s2 [( g
见60335-2-29 clause 3.19:0 M! n4 x6 l3 K8 D0 O* d
normal operation
. ?7 a0 ]/ |1 D; Moperation of the appliance under the following conditions. x) ]# T6 B" H/ `& }9 V
Battery chargers for charging lead-acid batteries, and other battery chargers having a rated
3 O& O3 O: ~; L: a( ]4 ud.c. output current not exceeding 20 A, are connected to the circuit of Figure 101. The( n$ l' k9 B# f
variable resistor is adjusted so that the current in the circuit is the rated d.c. output current i* s7 r$ P, _' E
when the battery charger is supplied at rated voltage.
# X3 k% ^) [$ W, |7 \When the charging current is controlled by the state of charge of the battery, the variable5 J9 j+ C. P' n3 _
resistor and the capacitor are replaced by a discharged battery of the type and having the4 r# M( K. ~' k! Y
largest capacity specified in the instructions.
7 n9 G- p) N% U% pOther battery chargers are connected to a discharged battery of the type and having the" Q z0 B6 ~) L( a
largest capacity specified in the instructions./ M% r, H# x7 f
NOTE 101 Batteries are considered to be discharged when$ b! l; b* `6 @5 g7 _' _. X7 f
– for lead-acid batteries, the specific gravity of the electrolyte is less than 1,16;
# L$ j# X0 X% F# \4 I– for nickel-cadmium batteries, the voltage per cell is less than 0,9 V. |
|