|
本帖最后由 zhutongshuai 于 2011-12-24 12:33 编辑
% y' c" Y+ u; X3 T$ y( L$ r M4 K4 H* p; S6 {
CTL-OP 109 Laboratory Procedure For Acceptance of Thermocouple Wire) n9 P( {5 x5 ~
$ ^& @( ?2 Q( m' q; {8 hPROCEDURES0 ]* [0 ~* u9 J! [
4.1 Thermocouples shall be prepared by staff trained in preparation of thermocouples.
! m" |9 C* }2 }, |- P, T3 X4.2 Thermocouples are to be prepared as noted:
2 _" a7 J% d& A+ z; w4 G y c8 I, U4.2.1 Inner insulation stripped back approximately 1.5 mm from tip.
' o* f9 C- w! |! z( F9 n( u4.2.2 Outer insulation, if any, stripped back approximately 15 mm from tip.
/ R0 r. h/ O ]4.2.3 The tip is to be joined by a single point weld. Other reliable and consistent methods of joining the thermocouple wires may be used upon prior acceptance of the CTL. ( \" `9 A6 v- ]2 S7 b
! b+ H l2 K, x6 Q
Note – Dimensions given are typical, not required.3 U, i- w @2 a8 d( x3 T
5 S, b0 g4 r6 W% I/ F% g X% a- T4 O) H! H
5 }4 W8 o i" J
|
本帖子中包含更多资源
您需要 登录 才可以下载或查看,没有帐号?注册安规
x
评分
-
查看全部评分
|