|
UL1993 Self-Ballasted Lamps and Lamp Adapters+ g9 P9 B; Z/ A, h: P
6 U* ?; D1 c4 P5 s, T4 c4 R; M/ q
1 Scope, b. c: U0 m$ Q9 f1 y/ [9 H, o
1.1 These requirements are intended to cover both self-ballasted lamps and self-ballasted lamp adapters
2 [, \$ C5 h, B& ~% Crated 120 to 347 V AC nominal for connection to screw-, pin-base, and recessed single contact (RSC or
: e$ ?* F( `& m# Z+ \R7) lampholders. These devices are intended for use in accordance with the National Electrical Code,
) s; i* s5 r$ X3 s H& {9 cANSI/NFPA 70, and the Canadian Electrical Code, Part I, in non-hazardous locations, and the8 Z0 d% f* D- p- z" _( U
Instalaciones Eléctricas (utilización), NOM-001-SEDE.
$ e: I. ^8 X1 v" O1.2 These devices incorporate resistance, reactance, or electronic (solid-state) type ballasts or power
\3 @/ a" N" t, asupplies. These devices employ various lamp technologies including, but not limited to, incandescent,0 b' n l9 W. j% v* w- t
fluorescent, high-intensity discharge lamps, light-emitting diodes.( z" |' {' u* A1 Z
1.3 This standard does not apply to medium-to-medium base (E26) fittings that incorporate controls such' }5 o& S' `7 ]( z) Q) A/ Z3 q; J
as photocells, motion detectors, radio controls, or dimmers covered by other standards. B9 R. k$ K: \$ y! s% w
1.4 These devices are not intended for use with emergency exit fixtures or emergency exit lights. |
|