|
UL1993 Self-Ballasted Lamps and Lamp Adapters
. d9 x! l! U; \
/ Z+ U3 s$ Y! r& Z/ K7 L1 Scope2 S- T# B6 a$ g H( I' w) K6 X* I8 o
1.1 These requirements are intended to cover both self-ballasted lamps and self-ballasted lamp adapters
' `9 ~! @0 L' T( w- L2 X+ ^rated 120 to 347 V AC nominal for connection to screw-, pin-base, and recessed single contact (RSC or
6 Q* ?- V- X$ ?/ Q* J. i/ W7 @R7) lampholders. These devices are intended for use in accordance with the National Electrical Code,* @5 i6 z, X5 g
ANSI/NFPA 70, and the Canadian Electrical Code, Part I, in non-hazardous locations, and the* m4 `1 J$ \% l% d% l6 o
Instalaciones Eléctricas (utilización), NOM-001-SEDE.
# q3 }4 |7 W! B+ `1.2 These devices incorporate resistance, reactance, or electronic (solid-state) type ballasts or power
9 _+ G+ r/ a; U, f4 `3 q: _- ssupplies. These devices employ various lamp technologies including, but not limited to, incandescent,
/ j1 m& N7 O; B) s- s3 pfluorescent, high-intensity discharge lamps, light-emitting diodes.6 _2 h! h" d5 M$ m
1.3 This standard does not apply to medium-to-medium base (E26) fittings that incorporate controls such( B, \8 Q& t: A9 o$ I. j( O$ @ b% l
as photocells, motion detectors, radio controls, or dimmers covered by other standards." ^, e" V: g, R+ U8 s; V
1.4 These devices are not intended for use with emergency exit fixtures or emergency exit lights. |
|