|
我们的VDE插头测试失败,插销尺寸不合格,郁闷!
6 `/ J" k4 [# N4 ]# }! @( L- Z经多次联系,VDE工程师发了一份东西过来,无签名无公章,应该算是内部管控标准。
0 ]8 i( U* ]# v" ^ J1 d1 M0 L发上来让大家看看,参考一下吧!
1 _& a" i5 w" L/ x: u9 \3 n' T8 N+ p$ ~: {# y# x3 G1 ~: M
Old requirement: Apply the radius gauge 2,5 or 2,0!- }8 v1 _4 E8 E/ a/ S, K5 w( u# q' E. E
+ W1 C$ V" c3 h4 l* ~4 @/ x7 ~New requirement: 2 ]' z& ^5 `5 u) T4 A+ o
If the diameter of the plug pin is 4,8 +/- 0,06 than we will apply the following radius gauges: 2,25 or 2,5 or 2,75
4 a: b0 |6 l: j8 d6 AIf one of them can apply on the plug pin, the requirement is fulfilled!) K9 P6 y, P8 I; k# K
+ H# i3 X6 s( h, O9 _
If the diameter of the plug pin 4,0 +/- 0,06 (for example flat European plug) than we will apply the following radius gauges: 1,75 or 2,0 or 2,25 ( @" C( ?6 q! r; t! f3 p/ D7 b
If one of them can apply on the plug pin, the requirement is fulfilled! |
|