|
我们的VDE插头测试失败,插销尺寸不合格,郁闷!7 ~3 E8 Y( y: o$ e
经多次联系,VDE工程师发了一份东西过来,无签名无公章,应该算是内部管控标准。
& Z/ ?3 M0 D/ {发上来让大家看看,参考一下吧!
# b% k7 V' g' j; _0 G8 k: Z; X7 Z$ X" a5 s4 {; Y
Old requirement: Apply the radius gauge 2,5 or 2,0!, |3 O! V3 y& G1 [
' i& ?# [6 V) R5 m. _
New requirement: 5 \+ f% @. n$ P% D. Y
If the diameter of the plug pin is 4,8 +/- 0,06 than we will apply the following radius gauges: 2,25 or 2,5 or 2,75# o# K4 Q& n( n. t5 a
If one of them can apply on the plug pin, the requirement is fulfilled!# X$ h, |! y' F) F( ], g
0 [! Y$ a/ R1 O' m% t: CIf the diameter of the plug pin 4,0 +/- 0,06 (for example flat European plug) than we will apply the following radius gauges: 1,75 or 2,0 or 2,25
& v+ ]$ x5 q" w3 V% F+ b; J! WIf one of them can apply on the plug pin, the requirement is fulfilled! |
|