|
关于ETL logo的大小问题, 我发邮件问了ITS那边,他们给我回复了, 我摘抄了其中的一段话出来:5 ]. b. I- x8 E! X: l, W
• You may enlarge or reduce the Mark proportionally," T5 O2 R* \5 }) r6 q7 n% s/ A
but it cannot be changed in any other way. Care
1 l0 l) U0 H+ V( Kshould be taken when printing a Mark on a
5 o% }1 s& N* A1 {product, this should be as large as the space will% Z( X% P% G& e* d. H$ _
allow, typically above 13mm wide (0.5”). Printing
7 X( k* j9 j, x) k7 kof smaller sized marks is allowed, but all parts of
, L2 F1 h4 M' H' R9 othe mark must be clearly legible when viewed% k5 _$ W9 U0 G: x7 L
on the product. The registration symbol, ®, or
* n: u! Z' w* {0 |. m' HCM (where applicable) must be visible. In special( N2 ?( I. P8 u" F- t# O
circumstances where the physical size of the
6 n% d( ]( B! }* a# L' Iproduct means that this is not possible then you: q5 j/ P& d. L2 z" \+ c7 m+ m- L
may apply for authorisation to use an alternative- M" e1 v" `7 ]) F& n$ s8 O
“small variant” of the Mark, obtainable from your
* M0 G M+ q4 A$ mlocal certification office. On literature, the minimum: ^/ Q2 }+ k+ }1 K a
size of reproduction should be 25mm (1”) wide. |
|