|
我们的VDE插头测试失败,插销尺寸不合格,郁闷!& a/ r/ b$ J: E( j
经多次联系,VDE工程师发了一份东西过来,无签名无公章,应该算是内部管控标准。
& d. s7 D0 [# P* z# @4 P发上来让大家看看,参考一下吧!
5 J% M( f0 R R0 v- H; m& k( u# b. d; P" {/ u+ ?6 T) x/ y$ e, [, r( z
Old requirement: Apply the radius gauge 2,5 or 2,0!
2 j7 w3 B+ A6 d! ]% K8 Y# o/ ]% f& q6 w
New requirement: 2 P# f: A% c' c `) F: h
If the diameter of the plug pin is 4,8 +/- 0,06 than we will apply the following radius gauges: 2,25 or 2,5 or 2,75# B* e! R. |4 l7 b! y( G3 D3 s
If one of them can apply on the plug pin, the requirement is fulfilled!' q3 {; ^+ o" [. p
. b9 g0 r4 w7 D1 \2 kIf the diameter of the plug pin 4,0 +/- 0,06 (for example flat European plug) than we will apply the following radius gauges: 1,75 or 2,0 or 2,25
+ f( `- D8 |9 ]% [. C, b& IIf one of them can apply on the plug pin, the requirement is fulfilled! |
|