如图 倾斜测试需要将玻璃缸拿出来吗？
如图15°倾斜测试需要将玻璃缸拿出来，盖子打开吗？http://bbs.angui.org/data/attachment/album/201208/14/2018277c7up77pqqupbuu4.jpg
本帖最后由 329485466 于 2012-8-15 19:21 编辑
520168 发表于 2012-8-15 08:52 http://bbs.angui.org/static/image/common/back.gif
15°倾斜测试不需要将玻璃缸拿出来，盖子打开测试一次,盖子关闭测试一次.
倾斜测试应该是测正常使用时最不 ...
10°倾斜测试是不是也不用把玻璃缸拿出来，
现做3C，测试机构要求把玻璃缸拿出来，锅盖打开。
锅盖打开可以理解，
玻璃缸拿出来就有点不能理解了。
玻璃缸只有在清洗时才拿出来，不知这算正常使用不？
不知是否可通过说明书来避免拿出玻璃缸来做10°倾斜的测试？
玻璃缸不拿出来，10°和15°都能过。 建议楼主仔细看下标准第20章，说的很清楚：
20 Stability and mechanical hazards
20.1 Appliances, other than fixed appliances and hand-held appliances, intended to be
used on a surface such as the floor or a table shall have adequate stability.
Compliance is checked by the following test, appliances incorporating an appliance inlet being
fitted with an appropriate connector and flexible cord.
The appliance is placed in any normal position of use on a plane inclined at an angle of 10° to
the horizontal, the supply cord resting on the inclined plane in the most unfavourable
position. However, if part of an appliance comes into contact with the horizontal supporting
surface when the appliance is tilted through an angle of 10°, the appliance is placed on a
horizontal support and tilted in the most unfavourable direction through an angle of 10°.
NOTE 1 The appliance is not connected to the supply mains.
NOTE 2 The test on the horizontal support may be necessary for appliances provided with rollers, castors or feet.
NOTE 3 Castors or wheels are blocked to prevent the appliance from rolling.
Appliances provided with doors are tested with the doors open or closed, whichever is the
more unfavourable.
Appliances intended to be filled with liquid by the user in normal use are tested empty or filled
with the most unfavourable quantity of water up to the capacity indicated in the instructions.
The appliance shall not overturn.
The test is repeated on appliances with heating elements with the angle of inclination
increased to 15°. If the appliance overturns in one or more positions, it is subjected to the
tests of clause 11 in each of these overturned positions.
During this test, temperature rises shall not exceed the values shown in table 9. The test is repeated on appliances with heating elements with the angle of inclination
* l" U4 m" B; s+ @# Eincreased to 15°. 15°倾斜测试不需要将玻璃缸拿出来，盖子打开测试一次,盖子关闭测试一次.
倾斜测试应该是测正常使用时最不利的位置 同意楼上的观点 我也觉得玻璃缸拿出来不合理,LZ有没有问3C机构为什么要拿出来?
LZ有没有试过拿出玻璃缸来做10°倾斜的测试能否通过.也可通过说明书注明拿出玻璃缸前要先关电源.
页:
[1]
