|
|
UL1993 Self-Ballasted Lamps and Lamp Adapters# K0 S8 |. v) G( Q4 c
: m% ^* @# t* u; N; {. [1 Scope
: L( K3 {! j9 R' U2 h7 u' [* C9 E1.1 These requirements are intended to cover both self-ballasted lamps and self-ballasted lamp adapters( d8 b, `( G# U# e3 G
rated 120 to 347 V AC nominal for connection to screw-, pin-base, and recessed single contact (RSC or
* h& u0 T6 Z t2 } sR7) lampholders. These devices are intended for use in accordance with the National Electrical Code,
" K% l: O1 v1 p, Z7 w4 ~/ }ANSI/NFPA 70, and the Canadian Electrical Code, Part I, in non-hazardous locations, and the9 j: A, _$ q; C7 `2 u* r
Instalaciones Eléctricas (utilización), NOM-001-SEDE.( E, Y: U8 k. S* ]5 `# e4 D' i
1.2 These devices incorporate resistance, reactance, or electronic (solid-state) type ballasts or power( A' m0 G' Y1 C" w7 B# m% Z! a
supplies. These devices employ various lamp technologies including, but not limited to, incandescent,' C( w6 g" O: r) z8 b
fluorescent, high-intensity discharge lamps, light-emitting diodes.
2 m2 Y# ~! T( P% K- e7 v1.3 This standard does not apply to medium-to-medium base (E26) fittings that incorporate controls such* D# o# C8 o' \+ U. I) F( s
as photocells, motion detectors, radio controls, or dimmers covered by other standards.
7 R6 N8 ~ j5 A' T1.4 These devices are not intended for use with emergency exit fixtures or emergency exit lights. |
|