|
|
請教UL 817 以下標準的中文意思?
! ^1 {4 O( D" L% Z# W這抗電弧測試是否只針對連接器呢 ?
" M% H: m L6 y4 m4 R" O: [5 X$ {' W/ G
14.7 Resistance to arcing test2 Z2 S, x5 d# s& K
14.7.1 The connector fittings that were subjected to 50 cycles of operation in the Overload test described) v l9 ~/ J# X
in 14.4 shall perform acceptably when subjected to an additional 200 cycles of operation under the2 c* h4 i8 I* \: l, v7 {; {5 `
overload test conditions following the temperature test and the repeated retention of plugs test.* `& C* l+ v+ O g, `8 [, h, p
14.7.2 Alternatively, six representative connector fittings may be subjected to the 50 cycles of operation5 n2 X- B% J2 F; W) O5 G7 V/ J
in the Overload test described in 14.4, followed by the Temperature test and repeated Retention of blades. q# B% O) n' J' M; E% ?
test on the connector fittings, and then, to determine resistance to arcing, a second, previously untested
h. W. Y) b- `- \set of connector fittings may be subjected to 250 cycles of operation under the overload-test conditions.
3 N1 h/ `% C' M3 A- L% h14.7.3 The attachment plug used for this test may be changed after every 50 operations. There shall not+ _6 v- _ A; ?
be any sustained flaming of the material in excess of five seconds duration. There shall not be any0 _9 r. S" u8 E1 R
electrical tracking or the formation of a permanent carbon conductive path that results in a dielectric
9 O9 ^1 v* `" Y P9 z* gbreakdown, as determined by the application of a 60 Hz essentially sinusoidal potential of 1500 V
& A1 d2 v5 ~0 a0 A! c. n: o( C |
|