安规网

标题: 谁有越南PLUG 尺寸图 [打印本页]
作者: 阳光的湘湘    时间: 2013-12-23 14:35
标题: 谁有越南PLUG 尺寸图
各位:谁有越南PLUG 尺寸图,急需?
作者: stey    时间: 2013-12-23 15:37
越南由于历史原因，都是采用其他国家的插头
: L, A- R7 g$ @0 G3 C" X3 a: }& Z美标，NEMA 1-15P9 C, g9 ^- A9 n9 C1 T+ Z0 q
欧盟，CEE 7/16 EN 50075* E! _, o3 B2 x2 @/ {
英标，BS 1363 BS 546
作者: tangsina2012    时间: 2013-12-23 16:08
欧，美，法 标插头都行
作者: chiyu    时间: 2013-12-31 09:31
There is no specific mandatory plug requirement for products sold in Vietnam. However, the recommended types are the following:
; H" m* C6 G2 d1. Type “A” NEMA 1-15 (USA 2-pin, unearthed)
$ r; A1 U( _) }) |0 E6 M3 I2 `* X5 |2. Type “C" CEE 7/16 (Euro 2 pin, unearthed)* e$ V5 I' }* _% T' Q
Other types of plugs (grounded or ungrounded) for electronics products are also acceptable. For these types, a universal plug adapter is required to connect the unit to the mains source.



欢迎光临 安规网 (http://bbs.angui.org/) Powered by Discuz! X3.2