标题: 最近在看IEC 62133：2012 的标准经常遇到问题，请兄弟们帮忙解释，谢谢 [打印本页] 作者: yangcanluck 时间: 2013-8-7 21:00 标题: 最近在看IEC 62133：2012 的标准经常遇到问题，请兄弟们帮忙解释，谢谢 本帖最后由 yangcanluck 于 2013-8-7 21:01 编辑 / y2 A' v3 X- f+ ^$ o& f% j3 n" _1 P. v1 g2 ?, a! I
最近在看IEC 62133：2012 的标准经常遇到问题，如8.3.9条款中有一段话，不是很理解还请高手帮忙分析分析。; J) j0 V. P. Y+ _9 D! Y
Bottom surface of movingpart of the press equipment is made of Nitrile rubber or Acryl, which is put onthe 10 mm x 10 mm stainless steel shaft. The detail of pressing jigs shall beshown in Figure 2. Nitrile rubber bottom surface is for cylindrical cell test.For prismatic test 5 mm x 5 mm (2 mm thickness) Acryl is put on the Nitrilerubber. The fixture is moved down at the speed of 0,1 mm/s monitoring the cellvoltage. When voltage drop caused by the internal short circuit is detected,stop descent immediately and keep pressing jig in the position for 30 s andthen release the pressure. Voltage is monitored m-ore than 100 times per secondand if voltage is dropped more than 50 m V compare to the initial voltage, itis defined to internal short circuit has occurred. If the pressure reaches 800N for cylindrical cell and 400 N for prismatic cell, stop descent immediatelyand then keep in the position. & @1 V6 Y* ~9 `6 o' X1 P" M v7 d. w 2 l8 e% Y" h% T, l9 q: z哥哥们帮帮忙！这该怎么测试呢！; `8 z' q0 I' i7 u8 e9 q% G5 R( q 作者: novice-safty 时间: 2013-8-8 09:09
这个测试过程说的比较明显吧，并且要相应的治具，后面有图。 p, _0 P+ a! e+ [8 X
你确定要做这个测试？你确定这个cell不是聚合物的？% z& m+ y: X$ [/ b8 U5 N
看下8.3.9 a）This country specific test which is only applicable to France, Japan, Korea and * l6 z" X/ F) L- l6 w
Switzerland and is not required on polymer cells./ J! p. C: i" T
这个测试需要动手能强，先拆电池，装镍片，然后又装起来。我手脚不灵活，搞不定作者: happysarah 时间: 2014-7-14 09:27
正要学习电池标准，可否分享一下给我相应的标准呢？多谢多谢！
; J) j0 V. P. Y+ _9 D! Y
